Home › Engine / Hybrid System › 2WW ENGINE CONTROL › ECD SYSTEM › from 2015.10
RM3090E _51 Engine / Hybrid System _044372 2WW ENGINE CONTROL _0208480 ECD SYSTEM C

2WW ENGINE CONTROL  ECD SYSTEM  P0641  Sensor Reference Voltage "A" Circuit / Open  


DESCRIPTION

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory
P0641 Sensor Reference Voltage "A" Circuit / Open Power voltages (5 V as standard) supplied from ECM to throttle position sensor, accelerator pedal position sensor, turbo pressure sensor assembly and crankshaft position sensor, nozzle vane position sensor are lower or higher than appropriate thresholds.
(1 trip detection logic)
·

Diesel throttle body assembly (throttle position sensor)

·

Open or short in diesel throttle position sensor circuit

·

Accelerator pedal sensor assembly

·

Open or short in accelerator pedal sensor circuit

·

Turbo pressure sensor assembly

·

Open or short in turbo pressure sensor assembly circuit

·

Crankshaft position sensor

·

Open or short in crankshaft position sensor circuit

·

Nozzle vane position sensor (turbocharger sub-assembly)

·

Open or short in nozzle vane position sensor (turbocharger sub-assembly) circuit

·

ECM


Comes on DTC stored

CAUTION / NOTICE / HINT

NOTICE:

When replacing the ECM, the ECM needs registration and initialization.

Click hereEngine / Hybrid System>2WW ENGINE CONTROL>ECD SYSTEM>PRECAUTION


HINT:
·

When the ECM must be replaced, before replacing the ECM, perform the "Learning Values Save" function using the GTS. Then after installing the new ECM, perform all of the initialization/registrations for the "Learning Values Write" function by following the instructions shown on the GTS display.

·

Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.



PROCEDURE

1.CHECK DTC OUTPUT
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON and turn the GTS on.


c.

Enter the following menus: Engine and ECT / Trouble Codes.

Powertrain > Engine and ECT > Trouble Codes
50001 371

d.

Read the DTCs.

OK:

DTCs related to open or short circuits in the diesel throttle position sensor, accelerator pedal position sensor, turbo pressure sensor assembly, crankshaft position sensor and nozzle vane position sensor are not detected.



Result:
Proceed to
OK
NG



OK

2.REPLACE ECM

NG

2.REPLACE ECM

Result:
Proceed to
NEXT



NEXT

3.CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED
3.CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON and turn the GTS on.


c.

Clear the DTCs.

Powertrain > Engine and ECT > Clear DTCs
50002 371

d.

Turn the ignition switch off and wait for 60 seconds or more [A].


e.

Perform road test [B].


f.

Repeat [A] and [B] for the number of trips detected.


g.

Enter the following menus: Engine and ECT / Trouble Codes.

Powertrain > Engine and ECT > Trouble Codes
50001 371

h.

Confirm that the DTC is not output again.


Result:
Proceed to
NEXT



NEXT

END