The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during transmission control cable assembly removal/installation are shown below.
After the ignition switch is turned off, the navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.
1.SECURE VEHICLE
Fully apply the parking brake and chock a wheel.
Make sure to apply the parking brake and chock a wheel before performing this procedure.
If the vehicle is not secure and the shift lever is moved to N, the vehicle may suddenly move, possibly resulting in an accident or serious injury.
2.REMOVE BATTERY
89661
3.REMOVE ECM
74404B
4.REMOVE BATTERY CLAMP SUB-ASSEMBLY
53896B
5.REMOVE FRONT FENDER FRONT SPLASH SHIELD LH
53895B
6.REMOVE FRONT FENDER FRONT SPLASH SHIELD RH
51441
7.REMOVE NO. 1 ENGINE UNDER COVER
51420
8.REMOVE NO. 2 ENGINE UNDER COVER ASSEMBLY
17410
9.REMOVE FRONT EXHAUST PIPE ASSEMBLY
58166A
10.REMOVE FRONT FLOOR COVER LH (w/ Cover)
58165C
11.REMOVE FRONT FLOOR COVER RH (w/ Cover)
58152A
12.REMOVE FRONT LOWER NO. 1 FLOOR HEAT INSULATOR
Remove the 3 nuts and front lower No. 1 floor heat insulator from the vehicle body.
58810J
13.REMOVE CONSOLE BOX ASSEMBLY
58861B
14.REMOVE NO. 1 CONSOLE BOX DUCT
33820B
15.DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY
33820B
16.REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY
| *a | Clip |
| *b | 45° to 60° |
While disengaging the clip as shown in the illustration, disconnect the transmission control cable assembly from the transmission control shaft lever together with the clip.
Remove the clip and disconnect the transmission control cable assembly from the No. 1 transmission control cable bracket.
Remove the nut and disconnect the transmission control cable assembly from the vehicle body.
Remove the 2 nuts and then remove the transmission control cable assembly from the vehicle body.