The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the shift stroke sensor removal/installation are shown below.
After the ignition switch is turned off, the navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.
1.REMOVE BATTERY
12601B
2.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY
17750A
3.REMOVE INLET AIR CLEANER ASSEMBLY
4.REMOVE AIR CLEANER ASSEMBLY WITH AIR CLEANER HOSE
89661
5.REMOVE ECM
74404B
6.REMOVE BATTERY CLAMP SUB-ASSEMBLY
89419B
7.REMOVE SHIFT STROKE SENSOR
Disconnect the shift stroke sensor connector.
Remove the bolt and shift stroke sensor from the transaxle case sub-assembly.