The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during sliding roof housing removal/installation are shown below.
After the ignition switch is turned off, the navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) auxiliary battery terminal.
After the ignition switch is turned off, the navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) auxiliary battery terminal.
1. PRECAUTION
Be sure to read precaution thoroughly before servicing.
for HV Model with Occupant Classification System:
for Gasoline Model with Occupant Classification System:
w/o Occupant Classification System:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
63218S
2.REMOVE SLIDING ROOF SIDE GARNISH LH
Move the sliding roof glass sub-assembly to the fully tilted up position.
Detach the claw and remove the sliding roof side garnish LH.
63217R
3.REMOVE SLIDING ROOF SIDE GARNISH RH
Use the same procedure described for the LH side.
63201P
4.REMOVE SLIDING ROOF GLASS SUB-ASSEMBLY
Carrying the sliding roof glass sub-assembly from the vehicle must be performed by multiple people.
Be careful not to damage the sliding roof glass sub-assembly, body exterior or interior parts.
To prevent the sliding roof glass sub-assembly from becoming misaligned, move the sliding roof glass sub-assembly to the fully closed position before removing.
Move the sliding roof glass sub-assembly to the fully closed position.
Using a T25 "TORX" socket wrench, remove the 4 "TORX" screws and sliding roof glass sub-assembly.
Use the same procedure for the RH side and LH side.
5.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
for A25A-FXS:
Click hereGeneral>MAINTENANCE>A25A-FXS AUXILIARY BATTERY>REMOVAL
for A25A-FKS:
for M20A-FKS:
Click hereGeneral>MAINTENANCE>M20A-FKS BATTERY>REMOVAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
62180A
6.REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY LH
62170A
7.REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY RH
Use the same procedure described for the LH side.
8.DISCONNECT SLIDING ROOF DRAIN HOSE
Detach the sliding roof drain hose clamp and disconnect the 4 sliding roof drain hoses.
63203F
9.REMOVE SLIDING ROOF HOUSING SUB-ASSEMBLY
Remove the 4 bolts, 6 nuts and sliding roof housing sub-assembly.
If the removed nut is the same shape as that shown in the illustration, replace it the supplied replacement part.