Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE PEDAL (for LHD without Vacuum Brake Booster) › 2018.10–2019.02
RM3620E _54 Brake _076411 BRAKE SYSTEM (OTHER) _0377034 BRAKE PEDAL(for LHD without Vacuum Brake Booster) A

BRAKE SYSTEM (OTHER)  BRAKE PEDAL(for LHD without Vacuum Brake Booster)  INSTALLATION  


PROCEDURE

Hide 47121 1.INSTALL BRAKE PEDAL PAD

a.

Install the brake pedal pad to the brake pedal support assembly.


Hide 2.INSTALL BRAKE PEDAL SUPPORT ASSEMBLY

a.
C406503

Install the brake pedal support assembly with the 4 nuts.

Torque:
12.7 N*m (130 kgf*cm, 9 ft.*lbf)


b.
C406501

w/ clip:

i.

Install the 2 clips.



Hide 47264A 3.INSTALL PUSH ROD PIN

a.
C319792C03
0,0 0,0 false
V100144

Lithium Soap Base Glycol Grease


Apply lithium soap base glycol grease to the push rod pin.


b.
C406499

Connect the brake master cylinder push rod clevis to the brake pedal support assembly with the push rod pin, and install a new clip as shown in the illustration.

NOTICE:

Be sure to install the push rod pin in the correct direction.



Hide 4.INSTALL INSTRUMENT PANEL REINFORCEMENT ASSEMBLY WITH AIR CONDITIONING UNIT ASSEMBLY

Hide 47101A 5.INSTALL BRAKE PEDAL RETURN SPRING

a.
C406505C01
0,0 0,0 false
V100136

Front


Install the brake pedal return spring to the instrument panel reinforcement assembly and brake pedal support assembly as shown in the illustration.


Hide 47110 6.CONNECT BRAKE PEDAL SUPPORT ASSEMBLY

a.
C406495

Connect the brake pedal support assembly to the instrument panel reinforcement assembly with the bolt.

Torque:
15 N*m (153 kgf*cm, 11 ft.*lbf)


b.
C406493

Connect the 2 wire harness clamps to the brake pedal support assembly.


Hide 84345 7.INSTALL STOP LIGHT SWITCH MOUNTING ADJUSTER

Hide 84340 8.INSTALL STOP LIGHT SWITCH ASSEMBLY

Hide 87211A 10.INSTALL NO. 2 AIR DUCT

Hide 73900 11.INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

Hide 13.PERFORM INITIALIZATION AND CALIBRATION OF LINEAR SOLENOID VALVE AND ZERO POINT OF YAW RATE AND ACCELERATION SENSOR