Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › RADIATOR GRILLE › 2018.10–2020.08
RM3620E _59 Vehicle Exterior _076404 EXTERIOR PANELS / TRIM _0377208 RADIATOR GRILLE A

EXTERIOR PANELS / TRIM  RADIATOR GRILLE  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during radiator grille removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced (for Gasoline Model)
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Front bumper assembly (Including removal and installation)
·

Ultrasonic sensor detection angle

·

Ultrasonic sensor detection angle registration


Parking support brake system (for Gasoline model) (Click here)
·

Front television camera assembly (Including removal and installation)

·

Radiator grille assembly (Including removal and installation)


Front television camera view adjustment Panoramic view monitor system (for Gasoline model) (Click here)

Necessary Procedures After Parts Removed/Installed/Replaced (for HV Model)
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Front bumper assembly (Including removal and installation)
·

Ultrasonic sensor detection angle

·

Ultrasonic sensor detection angle registration


Parking support brake system (for HV model) (Click here)
·

Front television camera assembly (Including removal and installation)

·

Radiator grille assembly (Including removal and installation)


Front television camera view adjustment Panoramic view monitor system (for HV model) (Click here)

HINT:
·

When the front bumper is damaged or deformed due to an accident or contact with other objects, etc., or the bumper installation area on the body is repaired, it is necessary to perform millimeter wave radar sensor adjustment.

Click hereEngine / Hybrid System>CRUISE CONTROL>MILLIMETER WAVE RADAR SENSOR>ADJUSTMENT



PROCEDURE

Hide 85271 2.REMOVE NO. 1 HEADLIGHT CLEANER HOSE (except Off Road Package, w/ Headlight Cleaner System)

a.
B530376C01
0,0 0,0 false
V100135

Push
V113147

Disconnect in this Direction


Detach the claw and disconnect the No. 1 headlight cleaner hose as shown in the illustration.

HINT:

Use the same procedure as for the RH and LH side.



b.

Detach the clamp and remove the No. 1 headlight cleaner hose.

B526275


Hide 88211B 3.REMOVE MILLIMETER WAVE RADAR SENSOR ASSEMBLY (w/ Dynamic Radar Cruise Control System)

Hide 4.REMOVE FOG LIGHT SEAL (except Off Road Package, w/o TOYOTA Parking Assist-sensor System)

Hide 82114 5.REMOVE NO. 4 ENGINE ROOM WIRE (w/ Wire Harness)

Hide 53112A 7.REMOVE LOWER RADIATOR GRILLE (except Off Road Package)

a.
B526218C01
0,0 0,0 false
V113147

Remove in this Direction


Detach the claw and guide to remove the lower radiator grille as shown in the illustration.


Hide 53111 8.REMOVE RADIATOR GRILLE (for Off Road Package)

a.
B526216C01
0,0 0,0 false
V113147

Remove in this Direction


Detach the claw and remove the radiator grille as shown in the illustration.