Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
89170
1.INSTALL AIRBAG SENSOR ASSEMBLY
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) auxiliary battery terminal.
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
If this procedure is performed without disconnecting the negative (-) auxiliary battery terminal, the airbag may deploy even if an impact is applied only to the airbag sensor assembly. Therefore, make sure that the negative (-) auxiliary battery terminal is disconnected before performing this procedure.
Install the airbag sensor assembly with the 3 bolts.
If the airbag sensor assembly has been dropped, or there are any cracks, dents or other defects in the case or connector, replace the airbag sensor assembly with a new one.
When installing the airbag sensor assembly, be careful that the SRS wiring does not interfere with or is not pinched between other parts.
When the ignition switch is first turned to ON after the airbag sensor assembly has been replaced, make sure that no one is in the vehicle.
|
Push in |
Connect the 3 connectors and push in the lock lever to lock the connector.
When connecting any airbag connector, take care not to damage the airbag wire harness.
Check that there is no looseness in the installation parts of the airbag sensor assembly.
58861B
2.INSTALL NO. 1 CONSOLE BOX DUCT
58810J
3.INSTALL CONSOLE BOX ASSEMBLY
4.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
for A25A-FKS:
for M20A-FKS:
for A25A-FXS:
Click hereGeneral>MAINTENANCE>A25A-FXS AUXILIARY BATTERY>INSTALLATION
for A25B-FXS:
Click hereGeneral>MAINTENANCE>A25B-FXS AUXILIARY BATTERY>INSTALLATION
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
65351A
5.INSTALL BATTERY HOLE COVER (for HV Model)
58416K
6.INSTALL REAR NO. 2 FLOOR BOARD (for HV Model)
58410B
7.INSTALL DECK BOARD ASSEMBLY (for HV Model)
8. PERFORM DIAGNOSTIC SYSTEM CHECK
w/o Occupant Classification System:
for Gasoline Model with Occupant Classification System:
for HV Model with Occupant Classification System:
9.CHECK SRS WARNING LIGHT
w/o Occupant Classification System:
for Gasoline Model with Occupant Classification System:
for HV Model with Occupant Classification System:
10.PERFORM SYSTEM INITIALIZATION AND CALIBRATION