Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › PARKING ASSIST MONITOR SYSTEM › 2019.02–2020.05
RM3620E _56 Audio / Visual / Telematics _076129 PARK ASSIST / MONITORING _0370834 PARKING ASSIST MONITOR SYSTEM T

PARK ASSIST / MONITORING  PARKING ASSIST MONITOR SYSTEM  PROBLEM SYMPTOMS TABLE  


NOTICE:
·

The following inspection procedures for the parking assist monitor system are based on the assumption that the navigation system is normal. If the navigation system*1 or audio and visual system*2 has any malfunction, first proceed with troubleshooting of the navigation system*1 or audio and visual system*2.

*1: w/ Navigation System

*2: w/ Audio and Visual System (for Radio and Display Type)

·

Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM>CALIBRATION

·

The vehicle is equipped with a Supplemental Restraint System (SRS) which includes components such as airbags. Before servicing (including removal or installation of parts), be sure to read the precaution for Supplemental Restraint System.

w/o Occupant Classification System:

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (w/o Occupant Classification System)>PRECAUTION

w/ Occupant Classification System (for HV Model with Occupant Classification System):

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (for HV Model with Occupant Classification System)>PRECAUTION

w/ Occupant Classification System (for Gasoline Model with Occupant Classification System):

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (for Gasoline Model with Occupant Classification System)>PRECAUTION

·

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When replacing the radio and display receiver assembly, always replace it with a new one.

If a radio and display receiver assembly which was installed to another vehicle is used, the following may occur:

-

A communication malfunction DTC may be stored.

-

The radio and display receiver assembly may not operate normally.

w/ Navigation System:

Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>PRECAUTION

w/ Audio and Visual System (for Radio and Display Type):

Click hereAudio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM (for Radio and Display Type)>PRECAUTION




HINT:
·

Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.

·

Inspect the fuses and relays related to this system before inspecting the suspected areas below.



General
Symptom Suspected Area Link
When the shift position is in R, an image of the area behind the vehicle is not displayed (screen is not black) Vehicle Signal Check Mode (Reverse Signal)*1 Click here
Vehicle Signal Check Mode (Reverse Signal)*2 Click here
Proceed to "Reverse Signal Circuit"*3 Click here
CAN communication system (for Gasoline Model)*5 Click here
CAN communication system (for HV Model)*4 Click here
Hybrid control system*4*6 Click here
Hybrid control system*4*7 Click here
Automatic transaxle system (UB80E)*5 Click here
Automatic transaxle system (UB80F)*5 Click here
Continuously variable transaxle system (K120)*5 Click here
Continuously variable transaxle system (K120F)*5 Click here
Television camera assembly Click here
Radio and display receiver assembly Click here
When the shift position is in R, an image of the area behind the vehicle is not displayed (screen is black) Proceed to "Image from Camera for Parking Assist Monitor is Abnormal" Click here
When the shift position is not in R, an image of the area behind the vehicle is displayed Vehicle Signal Check Mode (Reverse Signal)*1 Click here
Vehicle Signal Check Mode (Reverse Signal)*2 Click here
Proceed to "Reverse Signal Circuit"*3 Click here
CAN communication system (for Gasoline Model)*5 Click here
CAN communication system (for HV Model)*4 Click here
Hybrid control system*4*6 Click here
Hybrid control system*4*7 Click here
Automatic transaxle system (UB80E)*5 Click here
Automatic transaxle system (UB80F)*5 Click here
Continuously variable transaxle system (K120)*5 Click here
Continuously variable transaxle system (K120F)*5 Click here
Radio and display receiver assembly Click here
When the shift position is in R, an image of the area behind the vehicle is displayed and then switches to another image Vehicle Signal Check Mode (Reverse Signal)*1 Click here
Vehicle Signal Check Mode (Reverse Signal)*2 Click here
Proceed to "Reverse Signal Circuit"*3 Click here
CAN communication system (for Gasoline Model)*5 Click here
CAN communication system (for HV Model)*4 Click here
Hybrid control system*4*6 Click here
Hybrid control system*4*7 Click here
Automatic transaxle system (UB80E)*5 Click here
Automatic transaxle system (UB80F)*5 Click here
Continuously variable transaxle system (K120)*5 Click here
Continuously variable transaxle system (K120F)*5 Click here
Radio and display receiver assembly Click here

*1: w/ Navigation System

*2: w/ Audio and Visual System (for Radio and Display Type)

*3: for Manual Transaxle

*4: for HV Model

*5: for Gasoline Model except Manual Transaxle

*6: for 2WD

*7: for 4WD/AWD

Display Malfunction
Symptom Suspected Area Link
Parking assist monitor display malfunction (distortion of the color/screen) occurs continuously Proceed to "Image from Camera for Parking Assist Monitor is Abnormal" Click here
Parking assist monitor display malfunction (distortion of the color/screen) occurs temporarily Check the usage conditions (explain to the customer that the display may be temporarily distorted when the vehicle is close to an object that transmits radio waves, such as a telecommunication tower, an airport or a truck equipped with a transceiver) -

Parking Assist Monitor System Malfunction
Symptom Suspected Area Link
Estimated course lines are not displayed Parking assist monitor screen display mode settings (check that estimated course line display mode is selected) -
Correct the steering angle neutral point (initialization) Click here
Steering angle setting (calibration) Click here
Television camera assembly Click here
Steering sensor Click here
The estimated course lines stop moving before the steering wheel is fully turned to the right or left Steering angle setting (calibration) Click here
The vehicle width guide lines and estimated course lines do not match when the steering wheel is turned to the center position Check the installation of steering wheel Click here
Correct the steering angle neutral point (initialization) Click here
Steering angle setting (calibration) Click here
Check that the television camera assembly is correctly installed Click here
Back camera position setting (calibration) Click here
Television camera assembly Click here
Steering sensor Click here
The guide lines are not displayed even though the back door is closed Check that the No. 1 luggage compartment light assembly illuminates normally (if not, refer to Lighting System [INT] - Problem Symptoms Table) Click here
Television camera assembly Click here
The guide lines remain displayed even though the back door is open Check that the No. 1 luggage compartment light assembly illuminates normally (if not, refer to Lighting System [INT] - Problem Symptoms Table) Click here
Television camera assembly Click here
"!" is displayed. Correct the steering angle neutral point (Initialization) Click here
"!" mark remains displayed after the steering neutral point is corrected. Steering angle setting (calibration) Click here
Spiral cable sub-assembly Click here
Television camera assembly Click here
Guide lines and buttons are not displayed for all parking assist monitor screen display modes. CAN communication system (for Gasoline Model) Click here
CAN communication system (for HV Model) Click here
Proceed to "Back Door Courtesy Light Switch Circuit" in Lighting System (INT) Click here
Television camera assembly Click here
The guide lines and buttons remain displayed even though the back door is open. CAN communication system (for Gasoline Model) Click here
CAN communication system (for HV Model) Click here
Proceed to "Back Door Courtesy Light Switch Circuit" in Lighting System (INT) Click here
Television camera assembly Click here
When adjusting the camera optical axis, "You can not calibrate the camera when the door is open. Please close the door." is displayed even after the back door has been closed Check that the No. 1 luggage compartment light assembly illuminates normally (if not, refer to Lighting System [INT] - Problem Symptoms Table) Click here
Television camera assembly Click here
"CHK" message(s) are displayed on the signal check screen Signal check (diagnosis system) Click here
When an image of the area behind the vehicle is displayed, the lines are misaligned (the image from the camera is tilted) Back camera position setting (calibration) Click here
Television camera assembly Click here

Others
Symptom Suspected Area Link
A switch displayed on the parking assist monitor screen does not respond when pushed, or a switch other than the pushed switch responds. Proceed to "CHECK TOUCH SWITCH" in Navigation System*1 Click here
Proceed to "CHECK TOUCH SWITCH" in Audio and visual system (for Radio and Display Type)*2 Click here
Television camera assembly Click here
Radio and display receiver assembly Click here
A beep sound is not emitted when a switch displayed on the parking assist monitor screen is pushed. Check the setting on the audio screen (General setting) -
Proceed to "CHECK TOUCH SWITCH" in Navigation System*1 Click here
Proceed to "CHECK TOUCH SWITCH" in Audio and visual system (for Radio and Display Type)*2 Click here
Television camera assembly Click here
Radio and display receiver assembly Click here
The language of the messages displayed on the parking assist monitor screen cannot be changed. Check the setting on the audio screen (General setting) -
Television camera assembly Click here
Radio and display receiver assembly Click here
The switches displayed on the parking assist monitor screen are grayed out. Television camera assembly Click here
Radio and display receiver assembly Click here
The color of the switches displayed on the parking assist monitor screen are abnormal, or the switches are not dimmed when the headlights are turned on. Check the setting on the audio screen (Screen adjustment) -
Proceed to "CHECK TOUCH SWITCH" in Navigation System*1 Click here
Proceed to "CHECK TOUCH SWITCH" in Audio and visual system (for Radio and Display Type)*2 Click here
Television camera assembly Click here
Radio and display receiver assembly Click here

*1: w/ Navigation System

*2: w/ Audio and Visual System (for Radio and Display Type)