The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during brake booster assembly removal/installation are shown below.
After the ignition switch is turned off, the navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) auxiliary battery terminal.
Make sure to release vacuum from the brake booster assembly before removing the brake master cylinder sub-assembly from the brake booster assembly.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
47201
2.REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY
89661
3.REMOVE ECM
74404A
4.REMOVE BATTERY CLAMP SUB-ASSEMBLY
73900
5.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
87211
6.REMOVE NO. 2 AIR DUCT
84340
7.REMOVE STOP LIGHT SWITCH ASSEMBLY
47101A
8.REMOVE BRAKE PEDAL RETURN SPRING
9.SEPARATE WIRE HARNESS
Disconnect the connector.
Disengage the 2 clamps to separate the wire harness from the brake pedal support assembly.
10.LOOSEN LOCK NUT
| *1 | Lock Nut |
| *2 | Brake Master Cylinder Push Rod Clevis |
Loosen the lock nut of the brake master cylinder push rod clevis.
47264A
11.REMOVE PUSH ROD PIN
44772
12.DISCONNECT CHECK VALVE TO CONNECTOR TUBE HOSE
Slide the clip and disconnect the check valve to connector tube hose from the brake booster assembly.
44610
13.REMOVE BRAKE BOOSTER ASSEMBLY
Remove the bolt and nut.
Disengage the guide and separate the wire harness.
|
Protective Tape |
Apply protective tape to the vehicle body as shown in the illustration.
Disconnect the connector from the vacuum warning switch assembly.
w/ Stop and Start System:
Disconnect the connector from the vacuum sensor assembly.
Disengage the 5 clamps to separate the brake tube clamp from the brake lines.
Disengage the 5 clamps to remove the brake tube clamp from the brake lines.
Disengage the 5 clamps to remove the brake tube clamp from the brake lines.
Disengage the 3 clamps to separate the brake tube clamp from the brake lines.
Remove the bolt and clamp to remove the 2 brake tube clamps from the vehicle body.
| *a | From 1st Chamber of Brake Master Cylinder Sub-assembly |
| *b | From 2nd Chamber of Brake Master Cylinder Sub-assembly |
Using a union nut wrench, remove the 2 brake lines from the brake actuator assembly.
Do not kink or damage the brake lines.
Do not allow any foreign matter such as dirt or dust to enter the brake lines from the connecting parts.
Remove the 4 nuts.
Do not apply excessive force to the brake lines.
Remove the brake master cylinder push rod clevis and lock nut from the brake booster assembly.
Remove the brake booster assembly from the vehicle body.
Do not apply excessive force to the brake lines.
44785
14.REMOVE BRAKE BOOSTER GASKET
Remove the brake booster gasket from the brake booster assembly.