Home › Power Source / Network › NETWORKING › CAN COMMUNICATION SYSTEM

CAN COMMUNICATION SYSTEM > PROBLEM SYMPTOMS TABLE

for Preparation Click here


HINT:
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.


Result List of Check CAN Bus Line 
Symptom
Suspected Area
See page
The result of "How to Proceed with Troubleshooting" is "Open in CAN Main Wire"
Open in CAN Main Wire
Click here
The result of "How to Proceed with Troubleshooting" is "Short in CAN Bus Lines"
Short in CAN Bus Lines
Click here
The result of "How to Proceed with Troubleshooting" is "Short to B+ in CAN Bus Line"
Short to B+ in CAN Bus Line
Click here
The result of "How to Proceed with Troubleshooting" is "Short to GND in CAN Bus Line"
Short to GND in CAN Bus Line
Click here
The result of "How to Proceed with Troubleshooting" is "Open in One Side of CAN Branch Line"
Open in One Side of CAN Branch Line
Click here

Communication Stop Mode Table 
Symptom
Suspected Area
See page
ABS/VSC/TRC not displayed on the intelligent tester
Skid Control ECU Communication Stop Mode
Click here
Air Conditioner not displayed on the intelligent tester
Air Conditioning Amplifier Communication Stop Mode
Click here
Engine not displayed on the intelligent tester
ECM Communication Stop Mode
Click here
Main Body not displayed on the intelligent tester
Main Body ECU Communication Stop Mode
Click here
Combination Meter not displayed on the intelligent tester
Combination Meter ECU Communication Stop Mode
Click here
SRS Airbag not displayed on the intelligent tester
Center Airbag Sensor Communication Stop Mode
Click here
Steering Angle Sensor not displayed on the intelligent tester
Steering Angle Sensor Communication Stop Mode
Click here
Accessory Gateway not displayed on the intelligent tester*1
Bus Buffer ECU Communication Stop Mode
Click here
Air Suspension not displayed on the intelligent tester*2
Suspension Control ECU Communication Stop Mode
Click here
EPS not displayed on the intelligent tester
Power steering ECU Communication Stop Mode
Click here
*1: w/ Bus Buffer ECU
*2: w/ Air Suspension