Home › Brake › PARKING BRAKE › PARKING BRAKE PEDAL
RM27L0U _54 Brake _049325 PARKING BRAKE _0235755 PARKING BRAKE PEDAL A

PARKING BRAKE  PARKING BRAKE PEDAL  INSTALLATION  


PROCEDURE

Hide 46200 1.INSTALL PARKING BRAKE CONTROL PEDAL ASSEMBLY

a.
C154234

Install the control pedal to the body with the 3 nuts.

Torque:
13 N*m (128 kgf*cm, 9 ft.*lbf)


b.
C181290

Attach the wire harness clamp to the control pedal.


c.

Connect the parking brake switch connector.


Hide 46410 2.CONNECT NO. 1 PARKING BRAKE CABLE ASSEMBLY

a.
C155437

Connect the parking brake cable to the control pedal.


b.

Using needle-nose pliers, slowly bend down the claw.

NOTICE:

Be careful not to damage the parking brake cable or claw.



c.
C156829

Install a new clip to the control pedal.


d.
C154230

Temporarily install the adjustment nut and lock nut.

HINT:

The nuts will be tightened to a torque specification in the "Adjust Parking Brake Pedal Travel" procedure.



Hide 3.CHECK PARKING BRAKE PEDAL TRAVEL

Hide 4.ADJUST PARKING BRAKE PEDAL TRAVEL

Hide 55046A 6.INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH

Hide 53601 7.INSTALL HOOD LOCK CONTROL LEVER SUB-ASSEMBLY