Home › Steering › POWER ASSIST SYSTEMS › VANE PUMP(for 3UR-FE, 3UR-FBE)
RM27L0U _55 Steering _049326 POWER ASSIST SYSTEMS _0235761 VANE PUMP(for 3UR-FE, 3UR-FBE) A

POWER ASSIST SYSTEMS  VANE PUMP(for 3UR-FE, 3UR-FBE)  INSTALLATION  


PROCEDURE

Hide 44320 1.INSTALL VANE PUMP ASSEMBLY

HINT:

Before performing the following procedures, move the spacer until the vane pump can be installed.


A163333E11
1.75,1.844 1.688,1.844 false 1.677,1.813 0.875,1.625 true 1.792,1.76 2.469,2.177 0.677,0.417 10 true Spacer

a.
C161012

Install the vane pump with the 2 bolts.

Torque:
28 N*m (286 kgf*cm, 21 ft.*lbf)


Hide 44410 2.CONNECT PRESSURE FEED TUBE

a.
C181327

Install a new gasket to the pressure feed tube.


b.

Install the pressure feed tube with the union bolt.

Torque:
51 N*m (520 kgf*cm, 38 ft.*lbf)


Hide 3.CONNECT SOLENOID VALVE CONNECTOR

a.
C181333

Connect the solenoid valve connector.


Hide 4.CONNECT POWER STEERING OIL PRESSURE SENSOR CONNECTOR

a.
C181326

Connect power steering oil pressure sensor connector.


Hide 44348A 5.CONNECT NO.1 OIL RESERVOIR TO PUMP HOSE

a.
U153655

Connect the pump hose with the clip.


Hide 6.CONNECT WIRE HARNESS CLAMP

a.
C181324

Install the bracket with the bolt.

Torque:
28 N*m (286 kgf*cm, 21 ft.*lbf)


Hide 10.ADD POWER STEERING FLUID

Hide 12.INSPECT FOR POWER STEERING FLUID LEAK

Hide 14.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

Some systems need to be initialized after the cable is reconnected (see page Engine / Hybrid System>3UR-FE ENGINE MECHANICAL>ENGINE ASSEMBLY>INSTALLATION).