Home › Steering › POWER ASSIST SYSTEMS › VANE PUMP(for 3UR-FE, 3UR-FBE)
RM27L0U _55 Steering _049326 POWER ASSIST SYSTEMS _0235761 VANE PUMP(for 3UR-FE, 3UR-FBE) A

POWER ASSIST SYSTEMS  VANE PUMP(for 3UR-FE, 3UR-FBE)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:
·

After the ignition switch is turned off, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch off, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.

·

Some systems need to be initialized after the cable is reconnected (See page Engine / Hybrid System>3UR-FE ENGINE MECHANICAL>ENGINE ASSEMBLY>REMOVAL).



Hide 17700 4.REMOVE AIR CLEANER ASSEMBLY

Hide 6.DRAIN POWER STEERING FLUID

Hide 7.DISCONNECT WIRE HARNESS CLAMP

C181324

a.

Remove the bolt and disconnect bracket.


Hide 44348A 8.DISCONNECT NO. 1 OIL RESERVOIR TO PUMP HOSE

U153655

a.

Detach the clip and disconnect the hose.


Hide 9.DISCONNECT POWER STEERING OIL PRESSURE SENSOR CONNECTOR

a.
C181326

Disconnect the power steering oil pressure sensor connector.


Hide 10.DISCONNECT SOLENOID VALVE CONNECTOR

a.
C181333

Disconnect the solenoid valve connector.


Hide 44410 11.DISCONNECT PRESSURE FEED TUBE

a.
C181327

Remove the bolt and disconnect the pressure feed tube.


b.

Remove the gasket.


Hide 44320 12.REMOVE VANE PUMP ASSEMBLY

C161012

a.

Remove the 2 bolts and vane pump.