Home › Steering › STEERING COLUMN › STEERING COLUMN ASSEMBLY(for Power Tilt and Power Telescopic Steering Column)
RM27L0U _55 Steering _049327 STEERING COLUMN _0235764 STEERING COLUMN ASSEMBLY(for Power Tilt and Power Telescopic Steering Column) A

STEERING COLUMN  STEERING COLUMN ASSEMBLY(for Power Tilt and Power Telescopic Steering Column)  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).


PROCEDURE

Hide 1.PLACE FRONT WHEELS FACING STRAIGHT AHEAD

Hide 2. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 3. CUSTOMIZE INFORMATION

a.

Connect the Techstream to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the Techstream on.


d.

Enter the following menus: Utility / Customize Setting / Tilt & Telescopic.


e.

Turn the auto away/return function OFF.


f.

Turn the ignition switch to ACC.


g.

Operate the tilt and telescopic switch to fully raise the tilt and extend the steering wheel.


h.

Turn the ignition switch OFF.


Hide 4.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 45187 5.REMOVE LOWER NO. 3 STEERING WHEEL COVER

Hide 45186 6.REMOVE LOWER NO. 2 STEERING WHEEL COVER

Hide 45100 8.REMOVE STEERING WHEEL ASSEMBLY

Hide 11.REMOVE TILT AND TELESCOPIC MANUAL SWITCH

a.
C159804

Disconnect the connector.


b.

Using a screwdriver, detach the claw and pull out the tilt and telescopic switch.

NOTICE:

Pushing on the claw too hard will break the claw.


HINT:

Tape the screwdriver tip before use.



Hide 67914 13.REMOVE FRONT DOOR SCUFF PLATE LH

Hide 62112 14.REMOVE COWL SIDE TRIM BOARD LH

Hide 53601 16.REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

Hide 55046A 17.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH

Hide 73900 18.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

Hide 87201F 19.REMOVE NO. 3 AIR DUCT SUB-ASSEMBLY

a.
C154523

Remove the bolt and air duct.


Hide 45220 20.REMOVE STEERING INTERMEDIATE SHAFT ASSEMBLY

a.
C155149

Remove the 3 bolts and nut.


b.
C154524E02
1.25,0.938 0.99,1.708 true 1.094,1.01 0.99,1.688 true 0.844,1.677 1.594,1.854 0.75,0.177 10 false *a

Put matchmarks on the steering intermediate shaft and the steering column.

Text in Illustration
*a Matchmark


c.

Remove the bolt and steering intermediate shaft from the steering column.


d.
C155150E06
1.365,1.417 0.948,1.781 false 0.948,1.781 1.719,1.563 false 0.771,1.771 1.49,2.073 0.719,0.302 10 true *a

Put matchmarks on the No. 2 steering intermediate shaft and steering intermediate shaft.

Text in Illustration
*a Matchmark


e.

Remove the bolt.


f.

Separate the steering intermediate shaft from the No. 2 steering intermediate shaft.


Hide 45203 21.REMOVE NO. 2 STEERING INTERMEDIATE SHAFT SUB-ASSEMBLY

a.
C155151E07
0.646,1.667 1.646,1.365 false 0.646,1.667 1.677,1.594 false 0.438,1.573 0.646,1.781 0.208,0.208 10 false *a

Put matchmarks on the No. 2 steering intermediate shaft and power steering gear.

Text in Illustration
*a Matchmark


b.

Remove the bolt and No. 2 steering intermediate shaft from the power steering gear.


Hide 45250 22.REMOVE STEERING COLUMN ASSEMBLY

a.
C159218

Disconnect the connectors and disengage the wire.


b.

Remove the bolt and 2 nuts. Then remove the steering column from the instrument panel reinforcement.