Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC LASER CRUISE CONTROL SYSTEM
RM27L0U _51 Engine / Hybrid System _049309 CRUISE CONTROL _0235640 DYNAMIC LASER CRUISE CONTROL SYSTEM Y

CRUISE CONTROL  DYNAMIC LASER CRUISE CONTROL SYSTEM  HOW TO PROCEED WITH TROUBLESHOOTING  


CAUTION / NOTICE / HINT

HINT:
·

Use these procedures to troubleshoot the dynamic radar cruise control system.

·

*: Use the Techstream.



PROCEDURE

1.VEHICLE BROUGHT TO WORKSHOP
Result:
Proceed to
NEXT



NEXT

2.INSPECT BATTERY VOLTAGE
2.INSPECT BATTERY VOLTAGE
Standard Voltage:

11 to 14 V


If the voltage is below 11 V, replace or recharge the battery before proceeding.

Result:
Proceed to
NEXT



NEXT

3.CHECK COMMUNICATION FUNCTION OF CONTROLLER AREA NETWORK (CAN)*
3.CHECK COMMUNICATION FUNCTION OF CONTROLLER AREA NETWORK (CAN)*
a.

Use the Techstream to check for normal function of CAN communication system.

i.

Perform bus check (communication malfunction DTC).


ii.

Perform bus check (communication bus check).



Result:
Result Proceed to
DTC is not output A
DTC is output B



A

4.CHECK FOR DTC*

B

4.CHECK FOR DTC*

Refer to DTC Check/Clear.

Click hereEngine / Hybrid System>CRUISE CONTROL>DYNAMIC LASER CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR

a.

Check for DTC and note any codes that are output.


b.

Clear the DTC.


c.

Recheck for DTC. Try to prompt the DTC by simulating the original activity that the DTC suggests.


Result:
Result Proceed to
DTC does not reoccur A
DTC reoccur B



A

5.PROBLEM SYMPTOMS TABLE

B

7.ADJUST, REPAIR OR REPLACE
5.PROBLEM SYMPTOMS TABLE

Refer to the Problem Symptoms Table.

Click hereEngine / Hybrid System>CRUISE CONTROL>DYNAMIC LASER CRUISE CONTROL SYSTEM>PROBLEM SYMPTOMS TABLE

Result:
Result Proceed to
Fault is not listed in Problem Symptoms Table A
Fault is listed in Problem Symptoms Table B



A

6.OVERALL ANALYSIS AND TROUBLESHOOTING*

B

7.ADJUST, REPAIR OR REPLACE
6.OVERALL ANALYSIS AND TROUBLESHOOTING*

NEXT

7.ADJUST, REPAIR OR REPLACE
7.ADJUST, REPAIR OR REPLACE
NOTICE:
·

When the distance control ECU is replaced with a new one, initialization must be performed.

Click hereEngine / Hybrid System>CRUISE CONTROL>DYNAMIC LASER CRUISE CONTROL SYSTEM>INITIALIZATION

·

When the radar sensor is replaced with a new one, adjustment of the radar sensor beam axis must be performed.

Click hereEngine / Hybrid System>CRUISE CONTROL>LASER SENSOR>ADJUSTMENT



Result:
Proceed to
NEXT



NEXT

8.CONFIRMATION TEST
8.CONFIRMATION TEST
Result:
Proceed to
NEXT



NEXT

END