Home › Vehicle Exterior › WIPER / WASHER › WIPER SWITCH
RM3650E _59 Vehicle Exterior _079886 WIPER / WASHER _0387606 WIPER SWITCH A

WIPER / WASHER  WIPER SWITCH  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:
·
B475753

Airbag unit.

Danger! Life-threatening injuries!

-

All work on pyrotechnic parts may be carried out by technically experienced and appropriately trained personnel only.

-

Replace any damaged part or ones that have been dropped.

-

Before performing any work on the airbag, always disconnect the battery earth lead from the battery.

-

Airbag unit may only be set down with the cushion (airbag itself) facing upwards.

-

For additional information see: Safety regulations on handling components with gas generators.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION




HINT:
·

Use the same procedure for LHD and RHD vehicles.

·

The procedure listed below is for the LHD vehicles.



PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


CAUTION:
·
B422343

Wait at least 60 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

·

If the airbag deploys for any reason, it may cause a serious accident.



Hide 2.REMOVE STEERING WHEEL ASSEMBLY

Hide 45286B 3.REMOVE UPPER STEERING COLUMN COVER

Hide 45287 4.REMOVE LOWER STEERING COLUMN COVER

Hide 84310 5.REMOVE TURN SIGNAL SWITCH ASSEMBLY

a.
B536820

Using a deep socket wrench 7 mm, remove screws (1).


b.

Disconnect the turn signal switch assembly (2).


c.
B536821

Disconnect the connectors (1) to remove the turn signal switch assembly (2) with the spiral cable sub-assembly.


Hide 84306 6.REMOVE SPIRAL CABLE SUB-ASSEMBLY