Hot surfaces.
Risk of burning!
Perform all work only on components that have cooled down.
1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Click hereGeneral>MAINTENANCE>B48 BATTERY>REMOVAL
12601B
2.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY
12180E
3.REMOVE OIL FILLER CAP ASSEMBLY
15620
4.REMOVE OIL FILTER CAP ASSEMBLY
12101A
5.REMOVE OIL PAN DRAIN PLUG
51219
6.REMOVE FRONT SUSPENSION MEMBER LOWER PROTECTOR
12101A
7.INSTALL OIL PAN DRAIN PLUG
12140
8.REMOVE OIL PAN COVER
9.REMOVE ENGINE OIL LEVEL SENSOR
Hot surfaces.
Risk of burning!
Perform all work only on components that have cooled down.
Electrostatic discharge.
Damage to or destruction of electrical components.
Only touch the housings of electrical components. Do not touch pins or multi-pin connectors directly.
For additional information see:
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
Unlock and loosen connector (1).
Loosen nuts (2).
Remove the engine oil level sensor (3).