1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Click hereGeneral>MAINTENANCE>B58 BATTERY>REMOVAL
12601B
2.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY
17700
3.REMOVE AIR CLEANER ASSEMBLY
17880
4.REMOVE AIR CLEANER HOSE ASSEMBLY
16711
5.REMOVE FAN SHROUD
6.REMOVE FAN AND GENERATOR V BELT
51219
7.REMOVE FRONT SUSPENSION MEMBER LOWER PROTECTOR
28100
8.REMOVE STARTER ASSEMBLY
13470
9.REMOVE CRANKSHAFT PULLEY ASSEMBLY
Position special tool 0 496 595 (11 6 130) and fasten with bolt (1).
Slide counter support on the bolt (2) in direction of flywheel sub-assembly and turn the engine on the crankshaft pulley assembly until the gearing (3) engages in the flywheel sub-assembly.
Tighten the bolt (2).
Release E12 bolts (1) and remove the crankshaft pulley assembly (2) from the top.
10.REMOVE FRONT CRANKSHAFT OIL SEAL
Scratches.
Tools and sharp-edged components can cause scratches.
Protect working area.
Handle tools and components carefully.
Drive in the front crankshaft oil seal (1) in the marked area with a punch to approx. 1 cm deep.
Carefully lever out and remove the front crankshaft oil seal (1).