Home › Drivetrain › AXLE AND DIFFERENTIAL › STEERING KNUCKLE
RM3650E _52 Drivetrain _080261 AXLE AND DIFFERENTIAL _0389249 STEERING KNUCKLE A

AXLE AND DIFFERENTIAL  STEERING KNUCKLE  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 43212 1.INSTALL STEERING KNUCKLE

a.
C413457

Spread the steering knuckle (1) apart using special tool 0 494 541 (31 2 230).

SST
09600-WA030  


b.

Correctly align the gap at the steering knuckle (1) with the positioning pin (2) at the spring strut.


c.

Install holder.


d.

Replace the 18 mm bolt and 16 mm nut.


e.

Insert the 18 mm bolt and tighten the 16 mm nut.

Torque:
60 N*m (612 kgf*cm, 44 ft.*lbf)


f.

Using SST, tighten the 16 mm nut an additional 90°.

SST
09900-WA010  

HINT:
·
C417459C02
2.99,1.271 3.156,1.188 false 2.906,2.094 2.906,1.76 false 0.875,3 1.208,3 false 0.104,0.125 0.417,0.281 0.313,0.156 10 false *a 0.448,0.125 0.76,0.281 0.313,0.156 10 false *b 2.042,0.125 2.354,0.281 0.313,0.156 10 false *c 3.188,1.073 3.427,1.271 0.24,0.198 10 false *d 2.854,2.146 3.167,2.302 0.313,0.156 10 false *b 1.302,2.927 1.615,3.083 0.313,0.156 10 false *c
*a Example
*b Before Tightening
*c After Tightening
*d Magnetic Portion



·

The magnetic portion is used to secure the gauge to the vehicle.

·

After first adjusting the needle of the gauge to 0°, tighten to the specified angle.

·

Perform the work procedure carefully so that the gauge, etc. does not become tilted.




Hide 2.INSTALL BRAKE HOSE BRACKET

a.
C417463

Position the brake hose bracket (2) on the steering knuckle and tighten with the bolts (1).

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


Hide 45047 3.CONNECT TIE ROD END SUB-ASSEMBLY

Hide 4.CONNECT FRONT LOWER SUSPENSION ARM ASSEMBLY

Hide 43502C 5.INSTALL FRONT AXLE HUB SUB-ASSEMBLY

Hide 48630 6.CONNECT FRONT UPPER SUSPENSION ARM ASSEMBLY

Hide 7.INSTALL FRONT DISC BRAKE DUST COVER

a.
C413604

Install the front disc brake dust cover (2).


b.

Replace bolts (1).


c.

Tighten the bolts (1).

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


Hide 8.INSTALL FRONT BRAKE DISC (for 4-Pot Caliper)

Hide 9.INSTALL FRONT BRAKE DISC (except 4-Pot Caliper)

Hide 10.INSPECT AND ADJUST FRONT WHEEL ALIGNMENT