Home › Drivetrain › AXLE AND DIFFERENTIAL › REAR AXLE HUB
RM3650E _52 Drivetrain _080261 AXLE AND DIFFERENTIAL _0389250 REAR AXLE HUB A

AXLE AND DIFFERENTIAL  REAR AXLE HUB  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 42450B 1.INSTALL REAR AXLE HUB AND BEARING ASSEMBLY

a.
C413586

Make sure that the contact surfaces (1) of the wheel carrier and rear axle hub sub-assembly are clean, and free from oil and grease.

HINT:

If necessary, clean the contact surfaces (1).



b.
C413585C01
0.583,0.115 1.25,0.281 0.667,0.167 10 true *a
*a Long "TORX" Socket Wrench


Position rear axle hub sub-assembly (2).


c.

Replace T60 bolts (1).


d.

Tighten the T60 bolts (1).

Torque:
120 N*m (1224 kgf*cm, 89 ft.*lbf)


e.

Using SST, tighten the T60 bolts (1) an additional 90°.

SST
09900-WA010  

HINT:
C417459C02
2.99,1.271 3.156,1.188 false 2.906,2.094 2.906,1.76 false 0.875,3 1.208,3 false 0.104,0.125 0.417,0.281 0.313,0.156 10 false *a 0.448,0.125 0.76,0.281 0.313,0.156 10 false *b 2.042,0.125 2.354,0.281 0.313,0.156 10 false *c 3.188,1.073 3.427,1.271 0.24,0.198 10 false *d 2.854,2.146 3.167,2.302 0.313,0.156 10 false *b 1.302,2.927 1.615,3.083 0.313,0.156 10 false *c
*a Example
*b Before Tightening
*c After Tightening
*d Magnetic Portion


·

The magnetic portion is used to secure the gauge to the vehicle.

·

After first adjusting the needle of the gauge to 0°, tighten to the specified angle.

·

Perform the work procedure carefully so that the gauge, etc. does not become tilted.




Hide 48790 2.INSTALL REAR UPPER CONTROL ARM ASSEMBLY

Hide 51206A 3.INSTALL REAR SUSPENSION MEMBER SUB-ASSEMBLY

Hide 4.INSTALL REAR BRAKE DISC

Hide 42340B 5.INSTALL REAR DRIVE SHAFT ASSEMBLY

Hide 6.INSTALL REAR WHEEL

Hide 7.INSPECT AND ADJUST REAR WHEEL ALIGNMENT