Home › Drivetrain › AXLE AND DIFFERENTIAL › REAR DIFFERENTIAL SIDE GEAR SHAFT OIL SEAL
RM3650E _52 Drivetrain _080261 AXLE AND DIFFERENTIAL _0389273 REAR DIFFERENTIAL SIDE GEAR SHAFT OIL SEAL A

AXLE AND DIFFERENTIAL  REAR DIFFERENTIAL SIDE GEAR SHAFT OIL SEAL  REPLACEMENT  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 37100 1.REMOVE PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY

Hide 48738 2.REMOVE REAR SUSPENSION ARM COVER LH

Hide 48737 3.REMOVE REAR SUSPENSION ARM COVER RH

HINT:

Use the same procedure as for the LH side.


Hide 41110 4.REMOVE REAR DIFFERENTIAL CARRIER ASSEMBLY

Hide 5.REMOVE REAR DRIVE SHAFT OIL SEAL

a.
C413535

Pull out the rear drive shaft oil seal (1) using special tool 0 490 466 (00 5 010) or 0 492 104 (33 1 308).

SST
09500-WA090  
09900-WA210  


Hide 6.INSTALL REAR DRIVE SHAFT OIL SEAL

a.

Replace rear drive shaft oil seal at front.

HINT:

Rear drive shaft oil seal are equipped with an installation protection ring. The installation protection ring is used to protect the sealing lip when installing the rear drive shaft assembly.



b.
C413525

Install the rear drive shaft oil seal (2) using the installation protection ring (1).


c.

Make sure that the installation protection ring does not slide out of the rear drive shaft oil seal.


d.
C413536

w/o LSD:

i.

Coat housing sheet metal flange and the sealing lips of the new rear drive shaft oil seal with approved differential oil.


ii.

Tap in rear drive shaft oil seal with special tools 0 490 47 5 (00 5 500) and 0 495 313 (33 4 320) up to the limit position.

SST
09500-WA070  
09500-WA080  



e.
C413537

w/ LSD:

i.

Coat housing sheet metal flange and the sealing lips of the new rear drive shaft oil seal with approved differential oil.


ii.

Tap in rear drive shaft oil seal with special tools 0 495 860 (33 5 130) and 0 495 862 (33 5 140) up to the limit position.

SST
09500-WA060  
09500-WA210  



Hide 41110 7.INSTALL REAR DIFFERENTIAL CARRIER ASSEMBLY

Hide 48738 8.INSTALL REAR SUSPENSION ARM COVER LH

Hide 48737 9.INSTALL REAR SUSPENSION ARM COVER RH

HINT:

Use the same procedure as for the LH side.


Hide 37100 10.INSTALL PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY