Home › BRAKE › BRAKE CONTROL › ANTI-LOCK BRAKE SYSTEM

ANTI-LOCK BRAKE SYSTEM > PROBLEM SYMPTOMS TABLE

for Preparation Click here


If no DTCs are displayed during the DTC check but the problem still occurs, check the circuits for each problem symptom in the order given in the table below and proceed to the relevant troubleshooting page.

NOTICE:
When replacing the brake actuator or sensor, turn the ignition switch to OFF.


ANTI-LOCK BRAKE SYSTEM 
Symptom
Suspected Areas
See Page
ABS does not operate
1. Check DTC reconfirming that normal code output.
Click here
2. IG power source circuit
Click here
3. Speed sensor circuit
Click here
4. Check brake actuator with intelligent tester. If abnormal, check hydraulic circuit for leakage.
Click here
5. If symptoms still occur even after above circuits in suspected areas inspected and proved to be normal, replace brake actuator.
Click here
ABS does not operate efficiently
1. Check DTC reconfirming that normal code output.
Click here
2. Speed sensor circuit
Click here
3. Stop light switch circuit
Click here
4. Check brake actuator with intelligent tester. If abnormal, check hydraulic circuit for leakage.
Click here
5. If symptoms still occur even after above circuits in suspected areas inspected and proved to be normal, replace brake actuator.
Click here
ABS warning light abnormal
1. ABS warning light circuit
Click here
2. Skid control ECU (brake actuator)
Click here
DTC check cannot be performed
1. ABS warning light circuit
Click here
2. TC and CG terminal circuit
Click here
3. If symptoms still occur even after above circuits in suspected areas inspected and proved to be normal, replace brake actuator.
Click here
Speed sensor signal check cannot be performed
1. Skid control ECU (brake actuator)
Click here