Home › COMMUNICATION SYSTEM › CAN COMMUNICATION › CAN COMMUNICATION SYSTEM

CAN COMMUNICATION SYSTEM > PROBLEM SYMPTOMS TABLE

for Preparation Click here


HINT:
  1. Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
  2. Inspect the fuses and relays related to this system before inspecting the suspected areas below.


Result List of Check CAN Bus Line 
Symptom
Suspected Area
See page
The result of "How to proceed with Troubleshooting" is "Open in CAN Main Wire"
CAN Main Bus Line
Click here
The result of "How to Proceed with Troubleshooting" is "Short in CAN Bus Lines"
Short in CAN Bus Lines
Click here
The result of "How to Proceed with Troubleshooting" is "Short to B+ in CAN Bus Line"
Short to B+ in CAN Bus Line
Click here
The result of "How to Proceed with Troubleshooting" is "Short to GND in CAN Bus Line"
Short to GND in CAN Bus Line
Click here
The result of "How to Proceed with Troubleshooting" is "Open in One Side of CAN Branch Line"
Open in One Side of CAN Branch Line
Click here

HINT:
Refer to How to Proceed with Troubleshooting for the CAN V Bus Check procedure.


Communication Stop Mode Table 
Symptom
Suspected Area
See page
"Skid Control (ABS/VSC/TRAC)" is not displayed on the Techstream
Skid Control ECU Communication Stop Mode
Click here
"Air Conditioning Amplifier" is not displayed on the Techstream
Air Conditioning Amplifier Communication Stop Mode
Click here
"CAN Gateway1" is not displayed on the Techstream (w/ Blind Spot Monitor System)
Gateway ECU Communication Stop Mode
Click here
"Spiral cable (Steering Angle Sensor)" is not displayed on the Techstream
Steering Angle Sensor Communication Stop Mode
Click here
"ECM (Engine)" is not displayed on the Techstream
ECM Communication Stop Mode
Click here
"Main Body" is not displayed on the Techstream
Main Body ECU Communication Stop Mode
Click here
"Combination Meter" is not displayed on the Techstream
Combination Meter ECU Communication Stop Mode
Click here
"Airbag" is not displayed on the Techstream
Center Airbag Sensor Communication Stop Mode
Click here
"Four Wheel Drive Control" is not displayed on the Techstream (for 4WD)
4WD Control ECU Communication Stop Mode
Click here
"Display and Navigation (AVN1)" is not displayed on the Techstream (w/ Navigation System)
Navigation ECU Communication Stop Mode
Click here
"Display and Navigation (AVN1)" is not displayed on the Techstream (w/ Audio and Visual System)
Audio Receiver Assembly Communication Stop Mode
Click here
"Accessory Gateway" is not displayed on the Techstream (w/ Bus Buffer ECU)
Bus Buffer ECU Communication Stop Mode
Click here