Home › Engine / Hybrid System › 1UR-FE ENGINE CONTROL › POWER STEERING OIL PRESSURE SWITCH
RM27M0U _51 Engine / Hybrid System _049093 1UR-FE ENGINE CONTROL _0233906 POWER STEERING OIL PRESSURE SWITCH A

1UR-FE ENGINE CONTROL  POWER STEERING OIL PRESSURE SWITCH  INSTALLATION  


PROCEDURE

Hide 89438 1.INSTALL POWER STEERING OIL PRESSURE SWITCH

a.

Install a new O-ring to the power steering oil pressure switch.


b.

Apply a light coat of engine oil to the O-ring of the power steering oil pressure switch.

NOTICE:
·

When reusing the power steering oil pressure switch, inspect the O-ring.

·

If the O-ring has scratches or cuts, replace the power steering oil pressure switch.




c.
A217901E01
0.383,1.377 1.382,1.565 0.999,0.188 10 Fulcrum Length 1.827,0.122 2.156,0.272 0.328,0.150 10 SST 2.213,0.206 2.291,0.206 2.291,0.206 2.493,0.492 false 1.587,2.565 1.915,2.715 0.328,0.150 10 SST 1.972,2.648 2.05,2.648 2.05,2.648 2.253,2.934 false

Using SST, install the power steering oil pressure switch.

SST
09922-10010  

Torque:
without SST : 21 N*m (210 kgf*cm, 15 ft.*lbf)
with SST : 15 N*m (148 kgf*cm, 11 ft.*lbf)

HINT:
·

Use a torque wrench with a fulcrum length of 30 cm (11.8 in.). When using a torque wrench with a fulcrum length that is not 30 cm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).

·

Make sure SST and the torque wrench are connected in a straight line.




d.

Connect the oil pressure switch connector.


Hide 16361A 2.INSTALL FAN AND GENERATOR V BELT

a.

Install the fan and generator V belt (See page Engine / Hybrid System>1UR-FE ENGINE MECHANICAL>DRIVE BELT>INSTALLATION).


Hide 3.ADD POWER STEERING FLUID

Hide 5.INSPECT FOR POWER STEERING FLUID LEAK

Hide 53736 7.INSTALL FRONT FENDER APRON SEAL RH