Home › Engine / Hybrid System › 3UR-FBE ENGINE MECHANICAL › FRONT CRANKSHAFT OIL SEAL
RM27M0U _51 Engine / Hybrid System _049105 3UR-FBE ENGINE MECHANICAL _0234014 FRONT CRANKSHAFT OIL SEAL A

3UR-FBE ENGINE MECHANICAL  FRONT CRANKSHAFT OIL SEAL  INSTALLATION  


PROCEDURE

Hide 11301C 1.INSTALL FRONT CRANKSHAFT OIL SEAL

a.

Apply MP grease to the lip of a new oil seal.


b.
A163775E01
0.771,1.564 1.100,1.720 0.330,0.156 10 SST 1.828,1.177 1.152,1.648 1.152,1.648 1.871,1.366 false

Using SST and a hammer, tap in the oil seal to a depth between 0 to 1.0 mm (0 to 0.0394 in.) from the timing chain cover edge.

SST
09223-22010  
09506-35010  

NOTICE:
·

Keep the lip free from foreign matter.

·

Do not tap the oil seal at an angle.




Hide 13521A 2.INSTALL CRANKSHAFT TIMING GEAR KEY

a.
A163993

Install the crankshaft timing gear key.


Hide 15671 4.INSTALL OIL FILTER BRACKET SUB-ASSEMBLY (w/ Oil Cooler)

Hide 15781 5.INSTALL NO. 1 OIL COOLER BRACKET (w/ Oil Cooler)

Hide 16206A 6.CONNECT NO. 2 WATER BY-PASS PIPE SUB-ASSEMBLY (w/ Oil Cooler)

a.
A163800

Connect the 2 water by-pass hoses to the oil cooler.


b.

Install the 3 by-pass pipe bolts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


Hide 15671 7.INSTALL OIL FILTER BRACKET SUB-ASSEMBLY (w/o Oil Cooler)

Hide 83520 8.INSTALL OIL PRESSURE SENDER GAUGE ASSEMBLY

Hide 48811 9.CONNECT FRONT STABILIZER BAR

a.
A163793

Connect the stabilizer bar and install the 2 stabilizer bushes and 2 stabilizer brackets with the 4 bolts.

Torque:
69 N*m (704 kgf*cm, 51 ft.*lbf)


Hide 16571 12.INSTALL INLET RADIATOR HOSE