Home › Engine / Hybrid System › 3UR-FBE ENGINE MECHANICAL › FRONT CRANKSHAFT OIL SEAL
RM27M0U _51 Engine / Hybrid System _049105 3UR-FBE ENGINE MECHANICAL _0234014 FRONT CRANKSHAFT OIL SEAL A

3UR-FBE ENGINE MECHANICAL  FRONT CRANKSHAFT OIL SEAL  REMOVAL  


PROCEDURE

Hide 16571 4.REMOVE INLET RADIATOR HOSE

Hide 48811 7.DISCONNECT FRONT STABILIZER BAR

a.
A163772

Remove the 4 bolts, 2 stabilizer brackets and 2 stabilizer bushes. Then disconnect the stabilizer bar.


Hide 83520 8.REMOVE OIL PRESSURE SENDER GAUGE ASSEMBLY

Hide 15671 9.REMOVE OIL FILTER BRACKET SUB-ASSEMBLY (w/o Oil Cooler)

Hide 16206A 10.DISCONNECT NO. 2 WATER BY-PASS PIPE SUB-ASSEMBLY (w/ Oil Cooler)

a.
A163800

Remove the 3 bolts and disconnect the 2 water by-pass hoses from the oil cooler.


Hide 15781 11.REMOVE NO. 1 OIL COOLER BRACKET (w/ Oil Cooler)

Hide 15671 12.REMOVE OIL FILTER BRACKET SUB-ASSEMBLY (w/ Oil Cooler)

Hide 13521A 14.REMOVE CRANKSHAFT TIMING GEAR KEY

a.
A163993

Remove the crankshaft timing gear key from the crankshaft.


Hide 11301C 15.REMOVE FRONT CRANKSHAFT OIL SEAL

a.
A163774

Using a screwdriver, pry out the oil seal.

HINT:

Tape the screwdriver tip before use.


NOTICE:

Do not damage the surface of the oil seal press fit hole and crankshaft.