89533
1.INSTALL 4 WHEEL DRIVE CONTROL ECU
Connect the 2 connectors.
Install the 4 wheel drive control ECU with the 2 bolts, and then tighten them in the order shown in the illustration.
Be careful not to drop the 4 wheel drive control ECU.
Do not subject the 4 wheel drive control ECU to strong shocks.
2.INSTALL CLEARANCE WARNING ECU WITH BRACKET
55045A
3.INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY RH
for Column Shift Type: (See page Vehicle Interior>INTERIOR PANEL>INSTRUMENT PANEL SAFETY PAD(for Column Shift Type)>INSTALLATION)
for Floor Shift Type: (See page Vehicle Interior>INTERIOR PANEL>INSTRUMENT PANEL SAFETY PAD(for Floor Shift Type)>INSTALLATION)
4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).