Home › Brake › PARKING BRAKE › PARKING BRAKE CABLE
RM27M0U _54 Brake _049124 PARKING BRAKE _0234122 PARKING BRAKE CABLE A

PARKING BRAKE  PARKING BRAKE CABLE  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


Hide 55046A 4.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH

Hide 73900 5.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

Hide 6.RELEASE PARKING BRAKE PEDAL

Hide 7.DISCONNECT NO. 1 PARKING BRAKE CABLE ASSEMBLY

Hide 17450B 8.REMOVE FRONT NO. 2 EXHAUST PIPE ASSEMBLY

a.

for 1UR-FE:

Remove the front No. 2 exhaust pipe (See page Engine / Hybrid System>1UR-FE EXHAUST>EXHAUST PIPE>REMOVAL).


b.

for 3UR-FE:

Remove the front No. 2 exhaust pipe (See page Engine / Hybrid System>3UR-FE EXHAUST>EXHAUST PIPE>REMOVAL).


c.

for 3UR-FBE:

Remove the front No. 2 exhaust pipe (See page Engine / Hybrid System>3UR-FBE EXHAUST>EXHAUST PIPE>REMOVAL).


Hide 46410 9.REMOVE NO. 1 PARKING BRAKE CABLE ASSEMBLY (for 3700 mm [12 ft. 1.7 in.] Wheelbase Type)

a.

Remove the adjustment nut and lock nut (labeled A).

C325038E03
3.198,3.958 3.354,4.115 0.156,0.156 10 false C 3.646,4.177 3.802,4.333 0.156,0.156 10 false D 6.156,1.292 6.313,1.448 0.156,0.156 10 false A 2.542,0.563 2.698,0.719 0.156,0.156 10 false B 0.698,3.448 0.854,3.604 0.156,0.156 10 false E 1.646,3.5 1.802,3.656 0.156,0.156 10 false E 3.531,1.438 3.688,1.594 0.156,0.156 10 true F 3.958,1.646 4.115,1.802 0.156,0.156 10 true F 3.75,1.542 3.906,1.698 0.156,0.156 10 true F


b.

Remove the bolt (labeled B) and cable retainer.


c.

Remove the nut (labeled C) and No. 1 parking brake cable clamp from the body.


d.

Disconnect the No. 1 parking brake cable clamp (labeled D) from the No. 1 parking brake cable assembly.


e.

Remove the 2 bolts (labeled E) and No. 1 parking brake cable assembly from the inside of the vehicle.

NOTICE:

Do not bend and twist the parking brake cable.



f.

Remove the 3 bolts (labeled F) and No. 1 cable support bracket.


Hide 46410 10.REMOVE NO. 1 PARKING BRAKE CABLE ASSEMBLY (for 4180 mm [13 ft. 8.6 in.] Wheelbase Type)

a.

Remove the adjustment nut and lock nut (labeled A).

C325039E04
2.49,3.865 2.646,4.021 0.156,0.156 10 false C 4.167,3.385 4.323,3.542 0.156,0.156 10 false C 4.563,3.531 4.719,3.688 0.156,0.156 10 false D 2.781,4.052 2.938,4.208 0.156,0.156 10 false D 6.438,3.885 6.594,4.042 0.156,0.156 10 false A 6.438,3.885 6.594,4.042 0.156,0.156 10 false A 4.563,0.5 4.698,0.656 0.135,0.156 10 true B 5.875,1.354 6,1.51 0.125,0.156 10 true F 5.74,1.281 5.844,1.438 0.104,0.156 10 true F 6.042,1.438 6.177,1.604 0.135,0.167 10 true F 1.26,2.823 1.417,2.979 0.156,0.156 10 false E 0.385,2.771 0.542,2.927 0.156,0.156 10 false E


b.

Remove the bolt (labeled B) and cable retainer.


c.

Remove the 2 nuts (labeled C) and 2 No. 1 parking brake cable clamps from the body.


d.

Disconnect the 2 No. 1 parking brake cable clamps (labeled D) from the No. 1 parking brake cable assembly.


e.

Remove the 2 bolts (labeled E) and No. 1 parking brake cable assembly from the inside of the vehicle.

NOTICE:

Do not bend and twist the parking brake cable.



f.

Remove the 3 bolts (labeled F) and No. 1 cable support bracket.


Hide 11.REMOVE REAR WHEEL LH

Hide 12.DISCONNECT REAR DISC BRAKE CYLINDER ASSEMBLY LH

Hide 42431 13.REMOVE REAR DISC LH

Hide 14.REMOVE PARKING BRAKE SHOE RETURN SPRING LH

Hide 46580 15.REMOVE NO. 1 PARKING BRAKE SHOE ASSEMBLY LH

Hide 46590 16.REMOVE NO. 2 PARKING BRAKE SHOE ASSEMBLY LH

Hide 17.REMOVE PARKING BRAKE SHOE LEVER LH

Hide 46301A 18.REMOVE INTERMEDIATE LEVER TENSION SPRING

a.
C156990

Remove the intermediate lever tension spring.


Hide 46458A 19.REMOVE NO. 2 CABLE RETAINER

a.
C156991

Remove the bolt and No. 2 cable retainer.


Hide 46430 20.REMOVE NO. 3 PARKING BRAKE CABLE ASSEMBLY

a.

Remove the 6 bolts (labeled A and B) and disconnect the No. 3 parking brake cable assembly from the parking brake intermediate lever sub-assembly (labeled C).

NOTICE:

Do not bend and twist the parking brake cable.


C325042E01
0.395,0.843 0.551,0.999 0.156,0.156 10 A 1.902,1.131 2.057,1.286 0.156,0.156 10 A 4.024,0.78 4.180,0.936 0.156,0.156 10 A 3.877,3.211 4.033,3.367 0.156,0.156 10 A 2.791,2.924 2.947,3.080 0.156,0.156 10 A 5.789,3.421 5.945,3.577 0.156,0.156 10 B 1.012,2.91 1.168,3.066 0.156,0.156 10 C


b.
C154244

Remove the bolt and No. 3 parking brake cable assembly from the rear axle carrier.


Hide 21.REMOVE REAR WHEEL RH

Hide 22.DISCONNECT REAR DISC BRAKE CYLINDER ASSEMBLY RH

HINT:

Use the same procedures described for the LH side.


Hide 42431 23.REMOVE REAR DISC RH

HINT:

Use the same procedures described for the LH side.


Hide 24.REMOVE PARKING BRAKE SHOE RETURN SPRING RH

HINT:

Use the same procedures described for the LH side.


Hide 46540 25.REMOVE NO. 1 PARKING BRAKE SHOE ASSEMBLY RH

HINT:

Use the same procedures described for the LH side.


Hide 46550 26.REMOVE NO. 2 PARKING BRAKE SHOE ASSEMBLY RH

HINT:

Use the same procedures described for the LH side.


Hide 27.REMOVE PARKING BRAKE SHOE LEVER RH

HINT:

Use the same procedures described for the LH side.


Hide 46420 28.REMOVE NO. 2 PARKING BRAKE CABLE ASSEMBLY

a.

Disconnect the No. 2 parking brake cable assembly from the 2 clamps (labeled A).

C335411E02
4.313,1.406 4.469,1.563 0.156,0.156 10 false B 2.271,2.896 2.385,3.052 0.115,0.156 10 true B 2.063,0.385 2.219,0.542 0.156,0.156 10 true B 4.115,1.719 4.271,1.875 0.156,0.156 10 false A 6.49,4.167 6.646,4.323 0.156,0.156 10 false B 4.615,3.49 4.771,3.646 0.156,0.156 10 false D 5.344,2.594 5.479,2.75 0.135,0.156 10 true A 2.635,4.604 2.792,4.76 0.156,0.156 10 false B 2.333,4.063 2.49,4.219 0.156,0.156 10 false B 1,3.542 1.156,3.698 0.156,0.156 10 false C


b.

Remove the 6 bolts (labeled B) and disconnect the No. 2 parking brake cable assembly from the parking brake intermediate lever sub-assembly (labeled C).

NOTICE:

Do not bend and twist the parking brake cable.



c.

Remove the bolt (labeled D) and clamp.


d.
C156832

Remove the bolt and No. 2 parking brake cable assembly from the rear axle carrier.


Hide 46301 29.REMOVE PARKING BRAKE INTERMEDIATE LEVER SUB-ASSEMBLY

a.
C156999E02
2.039,2.666 2.236,2.468 2.236,2.468 2.378,2.468 false 2.408,2.385 2.564,2.541 0.156,0.156 10 *2 1.949,2.971 2.116,3.061 2.116,3.061 2.361,3.061 false 2.4,2.978 2.556,3.134 0.156,0.156 10 *1 1.519,2.816 1.343,3.014 1.343,3.014 1.132,3.014 false 0.922,2.93 1.077,3.086 0.156,0.156 10 *3 1.536,2.645 1.329,2.486 1.329,2.486 1.149,2.486 false 0.947,2.402 1.103,2.558 0.156,0.156 10 *4

Remove the 2 bolts and parking brake intermediate lever sub-assembly with parking brake intermediate lever bracket.

Text in Illustration
*1 Parking Brake Intermediate Lever Bracket
*2 Pin
*3 Clip
*4 Washer


b.

Remove the clip, washer, pin and parking brake intermediate lever sub-assembly from the parking brake intermediate lever bracket.


Hide 46452B 30.REMOVE NO. 2 CABLE SUPPORT BRACKET

a.
C159288

Remove the 2 bolts and No. 2 cable support bracket.