45250
1.INSTALL STEERING COLUMN ASSEMBLY
Install the steering column with the bolt and 2 nuts.
45203
2.INSTALL NO. 2 STEERING INTERMEDIATE SHAFT SUB-ASSEMBLY
Align the matchmarks on the No. 2 steering intermediate shaft and power steering gear.
| *a | Matchmark |
Install the bolt.
45220
3.INSTALL STEERING INTERMEDIATE SHAFT ASSEMBLY
Align the matchmarks on the steering intermediate shaft and No. 2 steering intermediate shaft.
| *a | Matchmark |
Install the bolt.
Align the matchmarks on the steering column and steering intermediate shaft.
| *a | Matchmark |
Install the bolt.
Install the 3 bolts and nut.
87201
4.INSTALL NO. 1 AIR DUCT SUB-ASSEMBLY
Install the air duct with the bolt.
73900
5.INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
55046A
6.INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH
55318C
7.INSTALL INSTRUMENT SIDE PANEL LH
62112
8.INSTALL COWL SIDE TRIM BOARD LH
67914
9.INSTALL FRONT DOOR SCUFF PLATE LH (for Regular Cab)
67914
10.INSTALL FRONT DOOR SCUFF PLATE LH (for Double Cab, CrewMax)
84306
11.INSTALL COMBINATION SWITCH ASSEMBLY WITH SPIRAL CABLE SUB-ASSEMBLY
Install the combination switch assembly with spiral cable to the steering column assembly with the clamp.
Connect the 5 connectors to the combination switch with spiral cable.
45286B
12.INSTALL UPPER STEERING COLUMN COVER
Attach the claw to install the upper steering column cover.
Attach the 4 clips.
45287
13.INSTALL LOWER STEERING COLUMN COVER
Attach the 2 claws to install the column cover.
Install the 2 screws.
14.INSTALL TILT AND TELESCOPIC MANUAL SWITCH
Attach the claw to install the tilt and telescopic switch.
Connect the connector.
15.ADJUST SPIRAL CABLE
45100
16.INSTALL STEERING WHEEL ASSEMBLY
Align the matchmarks on the steering wheel and steering main shaft.
| *a | Matchmark |
Install the steering wheel set nut.
17.INSPECT STEERING WHEEL CENTER POINT
18.ADJUST SPIRAL CABLE
45130
19.INSTALL STEERING PAD
45187
20.INSTALL LOWER NO. 3 STEERING WHEEL COVER
45186
21.INSTALL LOWER NO. 2 STEERING WHEEL COVER
22.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
23.CHECK SRS WARNING LIGHT