| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | REAR TRACTION MOTOR WITH TRANSAXLE ASSEMBLY | G1050 | - | - | - |
| 2 | REAR UPPER CONTROL ARM ASSEMBLY LH | 48790 | - | - | - |
| 3 | REAR UPPER CONTROL ARM ASSEMBLY RH | 48770A | - | - | - |
| 4 | LOWER CONTROL ARM ASSEMBLY LH | 48730 | - | - | - |
| 5 | LOWER CONTROL ARM ASSEMBLY RH | 48720 | - | - | - |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 6 | FRONT EXHAUST PIPE ASSEMBLY | 17410 | ( )
|
- | - |
| ● | Non-reusable part | - | - |
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rear suspension member sub-assembly removal/installation are shown below.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
G1050
1.REMOVE REAR TRACTION MOTOR WITH TRANSAXLE ASSEMBLY
48790
2.REMOVE REAR UPPER CONTROL ARM ASSEMBLY LH
48770A
3.REMOVE REAR UPPER CONTROL ARM ASSEMBLY RH
Perform the same procedure as for the LH side.
48730
4.REMOVE LOWER CONTROL ARM ASSEMBLY LH
48720
5.REMOVE LOWER CONTROL ARM ASSEMBLY RH
Perform the same procedure as for the LH side.
48812
7.REMOVE REAR STABILIZER BAR
890C0A
8.DISCONNECT NO. 2 PARKING BRAKE WIRE ASSEMBLY
51206A
9.REMOVE REAR SUSPENSION MEMBER SUB-ASSEMBLY
|
|
Using a transmission jack and a wooden block, support the rear suspension member sub-assembly.
Remove the 2 bolts and 2 nuts.
Slowly lower the rear suspension member sub-assembly.
When lowering the rear suspension member sub-assembly, be careful not to damage the vehicle body or other components installed to the vehicle.
890C0A
10.REMOVE NO. 2 PARKING BRAKE WIRE ASSEMBLY