| *A | w/o Differential Pressure Sensor | *B | w/ Differential Pressure Sensor |
| ● | Non-reusable part | - | - |
| *A | w/ Stud Bolt | *B | w/o Stud Bolt |
| *a | x1 or x2 | *b | x4 or x3 |
| ● | Non-reusable part | - | - |
| ● | Non-reusable part | - | - |
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during engine unit removal/installation are shown below.
25760
3.REMOVE VACUUM TRANSMITTING HOSE ASSEMBLY (w/ Differential Pressure Sensor)
23820
9.REMOVE FUEL VAPOR FEED HOSE ASSEMBLY
12262
10.REMOVE NO. 2 VENTILATION HOSE
25680
11.REMOVE EGR VALVE WITH EGR CCOLER ASSEMBLY
25624
13.REMOVE EGR VALVE ADAPTER
Using an 8 mm socket wrench, remove the bolt and EGR valve adapter from the camshaft housing sub-assembly.
17177
15.REMOVE NO. 1 INTAKE MANIFOLD TO HEAD GASKET
23901
16.REMOVE FUEL TUBE SUB-ASSEMBLY
Remove the fuel tube sub-assembly from the No. 2 fuel pipe sub-assembly.
Click hereEngine / Hybrid System>M15A-FKS (FUEL)>FUEL SYSTEM>PRECAUTION
23902
17.REMOVE NO. 2 FUEL TUBE SUB-ASSEMBLY
Remove the fuel pipe clamp from the fuel tube connector.
Remove the fuel tube sub-assembly from the No. 2 fuel pipe sub-assembly.
Click hereEngine / Hybrid System>M15A-FKS (FUEL)>FUEL SYSTEM>PRECAUTION
23802B
18.REMOVE NO. 2 FUEL PIPE SUB-ASSEMBLY
23470
19.REMOVE FUEL PUMP LIFTER ASSEMBLY
20.REMOVE WATER BY-PASS PIPE ASSEMBLY
82219C
21.REMOVE SENSOR WIRE
Disconnect the 4 connectors.
Disengage the 2 clamps.
Remove the bolt and sensor wire from the water inlet with thermostat sub-assembly.
82126A
22.REMOVE NO. 6 ENGINE WIRE
11452D
25.REMOVE OIL LEVEL GAGE GUIDE
Using an 8 mm socket wrench, remove the bolt and engine oil level dipstick guide from the cylinder head sub-assembly.
Remove the O-ring from the engine oil level dipstick guide.
16281
26.REMOVE NO. 4 WATER BY-PASS HOSE
27.REMOVE WIRE HARNESS CLAMP BRACKET
Using an 8 mm socket wrench, remove the bolt and wire harness clamp bracket from the camshaft housing sub-assembly.
Using an 8 mm socket wrench, remove the 2 bolts and wire harness clamp bracket from the camshaft housing sub-assembly.
Remove the 2 bolts and wire harness clamp bracket from the camshaft housing sub-assembly.