Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM › 2014.07–2017.01
RM19S0E _56 Audio / Visual / Telematics _051484 NAVIGATION / MULTI INFO DISPLAY _0248277 NAVIGATION SYSTEM C

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM  B15F6  Main Body ECU Vehicle Information Reading/Writing Process Malfunction  


DESCRIPTION

This DTC is stored when items controlled by the main body ECU cannot be customized via the navigation system vehicle customization screen.

HINT:
The main body ECU controls the items for the following systems that are customizable via the navigation receiver assembly screen:
·

Wireless door lock control system

·

Lighting system (INT)

·

Lighting system (EXT)



DTC Code DTC Detection Condition Trouble Area
B15F6 Main body ECU vehicle setting processing error.
·

CAN communication system

·

Wireless door lock control system

·

Lighting system (INT)

·

Lighting system (EXT)

·

Main body ECU

·

Navigation receiver assembly



CAUTION / NOTICE / HINT

NOTICE:

Check that the wire harness is properly installed and does not have any sharp bends, pinching or loose connections (See page General>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>ELECTRONIC CIRCUIT INSPECTION PROCEDURE).


PROCEDURE

1.CHECK CAN COMMUNICATION SYSTEM
a.

Use the GTS to check if the CAN communication system is functioning normally (See page Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(except Separate Type Yaw Rate Sensor)>DIAGNOSIS SYSTEM).

OK:

CAN communication DTCs are not output.




OK

2.CHECK LIGHTING SYSTEM (INT)

NG

2.CHECK LIGHTING SYSTEM (INT)
a.

Check if the lighting system (INT) is malfunctioning (See page Vehicle Interior>LIGHTING (INT)>LIGHTING SYSTEM>OPERATION CHECK).

HINT:

Customization may not be possible depending on the malfunction in the lighting system (INT).


OK:

No malfunctions are present in the lighting system (INT).




OK

3.CHECK LIGHTING SYSTEM (EXT)

NG

3.CHECK LIGHTING SYSTEM (EXT)
a.

Check if the lighting system (EXT) is malfunctioning (See page Vehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>OPERATION CHECK).

HINT:

Customization may not be possible depending on the malfunction in the lighting system (EXT).


OK:

No malfunctions are present in the lighting system (EXT).




OK

4.CHECK WIRELESS DOOR LOCK CONTROL SYSTEM

NG

4.CHECK WIRELESS DOOR LOCK CONTROL SYSTEM
a.

Check if the wireless door lock control system is malfunctioning (See page Vehicle Interior>DOOR LOCK>WIRELESS DOOR LOCK CONTROL SYSTEM>OPERATION CHECK).

HINT:

Customization may not be possible depending on the malfunction in the wireless door lock control system.


OK:

No malfunctions are present in the wireless door lock control system.




OK

5.CHECK CUSTOMIZE ITEMS

NG

5.CHECK CUSTOMIZE ITEMS
a.

Display the "Vehicle Customization" screen.


b.

Make a note of the customizable items for each main body ECU (instrument panel junction block assembly) related system.

HINT:

These items shown as customizable via the navigation receiver assembly vehicle customization screen can also be changed using the GTS. In a following step, the GTS will be used.


i.

To match-up the items in the navigation receiver assembly with the items on the GTS, check the customize parameters list for the wireless door lock control system related items that can be customized via the navigation receiver assembly screen (See page Vehicle Interior>DOOR LOCK>WIRELESS DOOR LOCK CONTROL SYSTEM>CUSTOMIZE PARAMETERS).


ii.

To match-up the items in the navigation receiver assembly with the items on the GTS, check the customize parameters list for the lighting system (INT) related items that can be customized via the navigation receiver assembly screen (See page Vehicle Interior>LIGHTING (INT)>LIGHTING SYSTEM>CUSTOMIZE PARAMETERS).


iii.

To match-up the items in the navigation receiver assembly with the items on the GTS, check the customize parameters list for the lighting system (EXT) related items that can be customized via the navigation receiver assembly screen (See page Vehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>CUSTOMIZE PARAMETERS).



c.

Using the GTS, confirm that it is possible to change the settings of the customize parameters that are available for customization via the navigation receiver assembly screen.

OK:

The items available for customization via the navigation receiver assembly screen can be customized successfully using the GTS.




OK

NG