Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING UNIT › 2014.07–2016.09
RM19S0E _58 Vehicle Interior _051498 HEATING / AIR CONDITIONING _0248353 AIR CONDITIONING UNIT A

HEATING / AIR CONDITIONING  AIR CONDITIONING UNIT  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (w/ VSC/Built-in Type Yaw Rate Sensor)>PRECAUTION).


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM

Hide 3.DRAIN ENGINE COOLANT (for 1NZ-FE)

Hide 4.DRAIN ENGINE COOLANT (for 2NZ-FE)

Hide 5.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 6.REMOVE WINDSHIELD WIPER MOTOR AND LINK

Hide 55815E 7.REMOVE FRONT NO. 1 VENTILATOR SEAL

Hide 55735D 8.REMOVE FRONT AIR SHUTTER SEAL RH

Hide 55722C 9.REMOVE COWL TOP TO COWL INNER BRACE

Hide 55711 10.REMOVE COWL TOP OUTER PANEL

Hide 88707B 11.DISCONNECT SUCTION TUBE SUB-ASSEMBLY B

a.
I105937

Remove the bolt.


b.

Turn the hook connector clockwise and disconnect the suction tube.


c.

Remove the O-ring from the suction tube.

NOTICE:

Seal the openings of the disconnected parts using vinyl tape to prevent the entry of moisture and foreign matter.



Hide 88706A 12.DISCONNECT LIQUID TUBE SUB-ASSEMBLY A

a.

Disconnect the liquid tube.


b.

Remove the O-ring from the liquid tube.

NOTICE:

Seal the opening of the disconnected parts using vinyl tape to prevent the entry of moisture and foreign matter.



Hide 87246A 13.DISCONNECT HEATER WATER OUTLET HOSE A

a.
I105939

Slide the clip and disconnect the heater water outlet hose from the air conditioning unit.


Hide 87245A 14.DISCONNECT HEATER WATER INLET HOSE A

a.
I105940

Slide the clip and disconnect the heater water inlet hose from the air conditioning unit.


Hide 55303B 15.REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY

Hide 45250 16.REMOVE STEERING COLUMN ASSEMBLY (for LHD)

Hide 45250 17.REMOVE STEERING COLUMN ASSEMBLY (for RHD)

Hide 55870B 18.REMOVE HEATER TO REGISTER DUCT ASSEMBLY

a.
I106173

Disengage the 3 claws and remove the heater to register duct.


Hide 55950G 19.REMOVE DEFROSTER NOZZLE ASSEMBLY

a.
I106174

Disconnect the connectors and disengage the clamps, then disconnect the wire harness.


b.
I106175

Disengage the 2 claws and 3 guides and remove the defroster nozzle.


Hide 88539J 20.SEPARATE DRAIN COOLER HOSE

a.
I106180

Separate the drain cooler hose.


Hide 55306A 21.REMOVE NO. 1 INSTRUMENT PANEL BRACE SUB-ASSEMBLY

a.
I106239

Disengage the 2 clamps.


b.

Remove the 2 bolts, nut and screw, then remove the instrument panel brace.

HINT:

If the vehicle is equipped with knee airbag, remove the knee airbag bracket mounting bolt.



Hide 82730 22.REMOVE INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY

a.
I105929

Disengage the clamps.


b.

Disconnect the connectors on the front side.


c.

Remove the bolt and separate the instrument panel junction block.


d.
I106069E02
2.635,0.219 2.792,0.396 0.156,0.177 10 false 1 2.271,0.625 2.385,0.823 0.115,0.198 10 true 2 2.667,1.583 2.823,1.76 0.156,0.177 10 false 3

Disconnect the back side connectors and remove the instrument panel junction block as shown in the illustration.


Hide 82141 23.SEPARATE INSTRUMENT PANEL WIRE (for LHD)

a.
I105973

Disconnect the connectors.


b.

Remove the screw.


c.

Disengage the 2 clamps and separate the connector holder.


d.
I106181

Remove the screw and the wire harness protector.


e.
I105952

Disconnect the connectors.


f.

Remove the bolt.


g.

Disengage the 3 clamps and remove the connector holder.


h.
I106870

for Automatic Air Conditioning System:

i.

Disconnect the 3 connectors.


ii.

Disengage the 2 clamps and disconnect the instrument panel wire.



i.
I106183

for Manual Air Conditioning System:

i.

Disconnect the 3 connectors.


ii.

Disengage the 3 clamps and disconnect the instrument panel wire.



j.

Remove the bolts and disconnect the ground wire.

I106184


k.

Disconnect the connectors and clamps, then disconnect the instrument panel wire.


Hide 82141 24.SEPARATE INSTRUMENT PANEL WIRE (for RHD)

a.
I105973

Disconnect the connectors.


b.

Remove the screw.


c.

Disengage the 2 clamps and separate the connector holder.


d.
I106068

Remove the screw and the wire harness protector.


e.
I105952

Disconnect the connectors.


f.

Remove the bolt.


g.

Disengage the 3 clamps and remove the connector holder.


h.
I105954

for Automatic Air Conditioning System:

i.

Disconnect the 2 connectors.


ii.

Disengage the 3 clamps and disconnect the instrument panel wire.



i.
I105955

for Manual Air Conditioning System:

i.

Disconnect the 3 connectors.


ii.

Disengage the 5 clamps and disconnect the instrument panel wire.



j.

Remove the bolts and disconnect the ground wire.

I106830


k.

Disconnect the connectors and clamps, then disconnect the instrument panel wire.


Hide 55331 25.REMOVE INSTRUMENT PANEL REINFORCEMENT

a.

Remove the 8 bolts and 3 screws, then remove the instrument panel reinforcement.

I106185


Hide 26.REMOVE AIR CONDITIONER UNIT ASSEMBLY

a.

Remove the 3 bolts and nut, then remove the air conditioner unit.

I106186


Hide 82210K 27.REMOVE AIR CONDITIONING HARNESS ASSEMBLY (for LHD)

a.
I106580

Disconnect the connectors and disengage the clamps, then remove the air conditioning harness.


Hide 82210K 28.REMOVE AIR CONDITIONING HARNESS ASSEMBLY (for RHD)

a.
I105959

Disconnect the connectors and disengage the clamps, then remove the air conditioning harness.


Hide 88650N 29.REMOVE AIR CONDITIONING AMPLIFIER ASSEMBLY (for Automatic Air Conditioning System)

a.
I106864

Disconnect the connector.


b.

Remove the screw.


c.

Disengage the claw and remove the air conditioning amplifier as shown in the illustration.


Hide 88650N 30.REMOVE AIR CONDITIONING AMPLIFIER ASSEMBLY (for Manual Air Conditioning System)

a.
I106865

Remove the screw.


b.

Disengage the claw and remove the air conditioning amplifier as shown in the illustration.


Hide 87050 31.REMOVE AIR CONDITIONING RADIATOR ASSEMBLY

a.
I106190

Remove the 3 screws and the air conditioning radiator.


Hide 88669B 32.REMOVE COOLER AIR HOSE (for Automatic Air Conditioning System)

a.
I105964

Remove the cooler air hose.


Hide 87211 33.REMOVE NO. 1 AIR DUCT

a.
I106191

Disengage the 3 claws and remove the air duct.


Hide 87211A 34.REMOVE NO. 2 AIR DUCT

a.
I105966

Disengage the 3 claws and remove the air duct.