64381A
1.INSTALL PACKAGE TRAY TRIM HANGER
Use the same procedures for the opposite side.
Install the package tray trim hanger.
82185
2.INSTALL NO. 2 BACK DOOR WIRE
| *a | Hook |
| *b | Clamp |
| *c | w/ Rear Window Defogger |
Engage the 5 clamps to install the No. 2 back door wire.
w/ Rear Window Defogger:
Connect the connector.
Connect the connector.
Engage the hook.
Install the bolt.
82184
3.INSTALL NO. 1 BACK DOOR WIRE (w/ Rear Window Defogger)
| *a | Hook |
| *b | Clamp |
Engage the clamp to install the No. 1 back door wire.
Connect the connector.
Engage the hook.
Install the bolt.
81270
4.INSTALL LICENSE PLATE LIGHT ASSEMBLY
67005B
5.INSTALL BACK DOOR PANEL CUSHION
Use the same procedures for the opposite side.
Install a new back door panel cushion.
67894B
6.INSTALL NO. 2 BACK DOOR PANEL PROTECTOR
Clean vehicle installation surface.
Remove the release paper from a new No. 2 back door panel protector.
|
Double-sided Tape |
Engage the 2 clips to install the No. 2 back door panel protector.
Press the double-sided tape area of the No. 2 back door panel protector.
67893A
7.INSTALL NO. 1 BACK DOOR PANEL PROTECTOR
Use the same procedure as for the No. 2 back door panel protector.
85345R
8.INSTALL REAR WASHER NOZZLE
81570
9.INSTALL CENTER STOP LIGHT ASSEMBLY
81952D
10.INSTALL REAR LIGHT COVER
Engage the 6 claws to install the rear light cover.
76085
11.INSTALL REAR SPOILER SUB-ASSEMBLY (w/ Rear Spoiler)
76894
12.INSTALL REAR SPOILER COVER LH (w/ Rear Spoiler)
76893A
13.INSTALL REAR SPOILER COVER RH (w/ Rear Spoiler)
Use the same procedure as for the LH side.
86790D
14.INSTALL REAR TELEVISION CAMERA ASSEMBLY (w/ Rear View Monitor System)
76827A
15.INSTALL NO. 2 BACK DOOR GARNISH RETAINER (w/o Rear View Monitor System)
Engage the 2 claws to install No. 2 back door garnish retainer.
Install the nut.
84840G
16.INSTALL BACK DOOR OPENER SWITCH ASSEMBLY
76801
17.INSTALL BACK DOOR OUTSIDE GARNISH SUB-ASSEMBLY
81590A
18.INSTALL REAR LIGHT ASSEMBLY LH
81580D
19.INSTALL REAR LIGHT ASSEMBLY RH
Use the same procedure as for the LH side.
74811D
20.INSTALL DOOR PULL HANDLE
Engage the 4 claws to install the door pull handle.
69350
21.INSTALL BACK DOOR LOCK ASSEMBLY
85143R
22.INSTALL REAR WIPER MOTOR GROMMET
85110R
23.INSTALL REAR WIPER MOTOR ASSEMBLY
24.INSTALL REAR WIPER ARM AND BLADE ASSEMBLY
85292A
25.INSTALL REAR WIPER ARM HEAD CAP
64746G
26.INSTALL REAR COMBINATION LIGHT SERVICE COVER LH
Engage the 2 guides and 2 claws to install the rear combination light service cover LH.
64745J
27.INSTALL REAR COMBINATION LIGHT SERVICE COVER RH
Use the same procedure as for the LH side.
67751
28.INSTALL BACK DOOR TRIM BOARD
Engage the 11 clips to install the back door trim board.
75442
29.INSTALL NO. 2 LUGGAGE COMPARTMENT DOOR NAME PLATE
75741E
30.INSTALL SYMBOL EMBLEM