Use the same procedure for the RH side and LH side.
The procedure listed below is for the LH side.
43420G
1.INSTALL FRONT DRIVE SHAFT HOLE SNAP RING
Install a new front drive shaft hole snap ring to the front drive shaft assembly.
43420
2.INSTALL FRONT DRIVE SHAFT ASSEMBLY LH
for CVT:
Coat the splines of the front drive inboard joint assembly with Toyota genuine CVT fluid FE.
for Manual Transaxle:
Coat the splines of the front drive inboard joint assembly with gear oil.
Coat the lip of the front drive shaft oil seal LH with MP grease.
Align the inboard joint splines, and using a brass bar and a hammer, install the front drive shaft assembly LH.
Face the end gap of the front drive shaft hole snap ring downward.
Do not damage the front drive shaft oil seal LH.
Do not damage the front axle inboard joint boot.
Make sure to center the front drive shaft assembly LH during installation to prevent damage to the front drive shaft hole snap ring.
Confirm whether the front drive shaft assembly LH is securely driven in by checking the reaction force and sound.
43410
3.INSTALL FRONT DRIVE SHAFT ASSEMBLY RH
Perform the same procedure as for the LH side.
43498A
4.INSTALL NO. 1 DRIVE SHAFT HEAT INSULATOR (for CVT)
43498A
5.INSTALL NO. 1 DRIVE SHAFT HEAT INSULATOR (for Manual Transaxle)
6.INSTALL FRONT AXLE ASSEMBLY
| *a | Matchmark |
Align the matchmarks and install the front axle assembly to the front drive shaft assembly LH.
Be careful not to damage the front axle outboard joint boot.
48069
7.INSTALL FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY
8.INSTALL FRONT STABILIZER BOLT (w/o Side Rail Reinforcement)
48810
9.INSTALL FRONT STABILIZER LINK ASSEMBLY (w/ Side Rail Reinforcement)
10.INSTALL TIE ROD END SUB-ASSEMBLY
47313A
11.INSTALL FRONT FLEXIBLE HOSE
Install the front flexible hose and front speed sensor wire to the front shock absorber assembly and body with the 2 bolts.
Install the front speed sensor wire and front flexible hose without twisting them.
Install the front speed sensor wire first and then the front flexible hose.
43502H
12.INSTALL FRONT AXLE SHAFT NUT
Clean the threaded parts on the front drive shaft assembly and a new front axle shaft nut using non-residue solvent.
Be sure to perform this work even when using a new front drive shaft assembly.
Keep the threaded parts free of oil and foreign matter.
Using a 30 mm deep socket wrench, install the front axle shaft nut.
Keep depressing the brake pedal to prevent the front drive shaft assembly from rotating.
Using a chisel and a hammer, stake the front axle shaft nut.
13.ADD CONTINUOUSLY VARIABLE TRANSAXLE FLUID (for CVT)
14.ADD MANUAL TRANSAXLE OIL (for Manual Transaxle)
15.INSPECT MANUAL TRANSAXLE OIL (for Manual Transaxle)
16.INSPECT FOR CONTINUOUSLY VARIABLE TRANSAXLE FLUID LEAK (for CVT)
17.INSPECT FOR MANUAL TRANSAXLE OIL LEAK (for Manual Transaxle)
51441C
18.INSTALL ENGINE UNDER COVER RH (w/o Metal Type Under Cover)
51442C
19.INSTALL ENGINE UNDER COVER LH (w/o Metal Type Under Cover)
51405A
20.INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY (w/ Metal Type Under Cover)
51451A
21.INSTALL CENTER ENGINE UNDER COVER (w/ Metal Type Under Cover)
22.INSTALL FRONT WHEELS
23.ADJUST FRONT WHEEL ALIGNMENT
24.CHECK FOR SPEED SENSOR SIGNAL