|
Perform Vehicle Identification Number (VIN) or frame number registration
|
Rough idle
|
( )
|
| Update ECU security key
|
Vehicle control history (RoB) are stored
|
( )
|
for 1KR-FE:
Throttle body with motor assembly
|
Input the learning value of the throttle position sensor
|
Rough idle
|
( )
|
|
Perform Vehicle Identification Number (VIN) or frame number registration
|
DTC P063051 is output
|
( )
|
If possible, read the transaxle compensation code from the previous ECM:
2.
Transfer transaxle compensation code
3.
Perform road test to allow ECM to learn
|
·
Deterioration of fuel efficiency
|
( )
|
If impossible, read the transaxle compensation code from the previous ECM:
2.
Reset transaxle compensation code
3.
Perform road test to allow ECM to learn
|
-
GPF deposition values save
-
GPF deposition values write
|
·
Deterioration of fuel efficiency
|
( )
|
| Update ECU security key
|
Vehicle control history (RoB) are stored
|
( )
|
for M15A-FKS:
·
Throttle body with motor assembly
·
Cleaning the deposits from the throttle body with motor assembly
·
Cylinder head sub-assembly
·
Camshaft (for intake or exhaust camshaft)
·
Camshaft timing gear assembly
·
Camshaft timing exhaust gear assembly
·
Fuel pump (for low pressure side)
·
Fuel pump assembly (for high pressure side)
·
Fuel pressure sensor (for low pressure side)
·
Fuel pressure sensor (for high pressure side)
·
Engine coolant temperature sensor
|
Inspection after repair
|
·
Engine start function, etc.
|
( )
|
for M15A-FKS:
Front exhaust pipe assembly*3
|
GPF deposition value clear
|
·
Deterioration of fuel efficiency
|
( )
|
|
Perform Vehicle Identification Number (VIN) or frame number registration
|
DTC P063051 is output
|
( )
|
-
GPF deposition values save
-
GPF deposition values write
|
·
Deterioration of fuel efficiency
|
( )
|
| Update ECU security key
|
Vehicle control history (RoB) are stored
|
( )
|
| ECU configuration
|
-
|
( )
|
for G16E-GTS:
·
Throttle body with motor assembly
·
Cleaning the deposits from the throttle body with motor assembly
·
Cylinder head sub-assembly
·
Camshaft (for intake or exhaust camshaft)
·
Camshaft timing gear assembly
·
Camshaft timing exhaust gear assembly
·
Fuel pump (for low pressure side)
·
Fuel pump assembly (for high pressure side)
·
Fuel pressure sensor (for low pressure side)
·
Fuel pressure sensor (for high pressure side)
·
Engine coolant temperature sensor
·
Turbocharger sub-assembly
|
Inspection after repair
|
·
Engine start function, etc.
|
( )
|
for G16E-GTS:
Front exhaust pipe assembly*3
|
GPF deposition value clear
|
·
Deterioration of fuel efficiency
|
( )
|
| Millimeter wave radar sensor assembly
|
Adjust millimeter wave radar sensor assembly
|
·
Dynamic Radar Cruise Control System
·
Lane Tracing Assist System
·
Front Radar Sensor System
·
Automatic High Beam System
|
Triangle Target:( )
Flat Surface Target:( )
Driving Adjustment:( )
|
| Update ECU security key
|
Vehicle control history (RoB) are stored
|
( )
|
| Forward recognition camera
|
Adjust forward recognition camera
|
·
Dynamic Radar Cruise Control System
·
Lane Tracing Assist System
·
Automatic High Beam System
|
One Time Recognition:
( )
Sequential Recognition:
( )
Driving Adjustment:( )
|
| Update ECU security key
|
Vehicle control history (RoB) are stored
|
( )
|
| Windshield glass (Including removal and installation)
|
Adjust forward recognition camera
|
·
Dynamic Radar Cruise Control System
·
Lane Tracing Assist System
·
Automatic High Beam System
|
One Time Recognition:
( )
Sequential Recognition:
( )
Sequential Recognition:
( )
|
| Continuously variable transaxle assembly
|
2.
Transaxle compensation code (Input)
3.
CVT oil pressure calibration
|
·
Deterioration of fuel efficiency
|
for Initialization:
( )
for Registration:
( )
|
| Transmission valve body assembly
|
2.
Transaxle compensation code (Initialize)
3.
CVT oil pressure calibration
|
| Oil pressure sensor
|
2.
CVT oil pressure calibration
|
| TCM
|
If transaxle compensation code read from TCM:
1.
Transfer transaxle compensation code
3.
CVT oil pressure calibration
4.
Perform road test to allow TCM to learn
|
If transaxle compensation code not read from TCM:
1.
Reset transaxle compensation code
3.
CVT oil pressure calibration
4.
Perform road test to allow TCM to learn
|
| Update ECU security key
|
Vehicle control history (RoB) are stored
|
( )
|
| CVT fluid
|
ATF thermal degradation estimate reset
|
The value of the Data List item "ATF Thermal Degradation Estimate" is not estimated correctly
|
( )
|
w/ Stop and Start System:
Bleed air from oil pump (continuously variable transaxle assembly)
|
Stop and Start System
|
( )
|
·
Tire pressure warning ECU and receiver
·
Tire pressure warning valve and transmitter
|
·
Initialize tire pressure warning system
|
·
DTC (Transmitter ID not Received) stored, tire pressure warning light blinks for 1 minute, then illuminates.
·
Tire pressure warning function
|
for Initialization:( )
for Registration:( )
|
| 4WD ECU assembly
|
1.
ECU Data Save (ECU being replaced)
2.
ECU Data Write (When replacing 4WD ECU assembly)
|
Active torque split AWD system
|
( )
|
| 4WD linear solenoid (transmission coupling assembly)
|
ECU Data Write (When replacing 4WD linear solenoid (transmission coupling assembly))
|
Active torque split AWD system
|
| Tire
|
ECU Data Initialization (When performing tire replacement after RoB code X2104 is output)
|
Active torque split AWD system
|
| Skid control ECU (brake actuator assembly)
|
Update ECU security key
|
Vehicle control history (RoB) are stored
|
( )
|
| Calibration
|
·
Slip indicator light illuminates
·
VSC disabled or malfunctions
|
for TMC Made:( )
for TMMF Made:( )
|
| Yaw rate and acceleration sensor (airbag sensor assembly)
|
Calibration
|
| Airbag sensor assembly
|
w/ Active Torque Split AWD System:
|
Active torque split AWD system
|
( )
|
| Update ECU security key
|
Vehicle control history (RoB) are stored
|
( )
|
w/ Stop and Start System:
- NOTICE:
-
When the starter assembly is replaced, "ST NO. 1 relay" must be also replaced.
|
Clear the number of starter operations
|
Stop and start system
|
( )
|
for CVT with Stop and Start System:
Oil pump with motor assembly
|
Check oil pump with motor assembly
|
| Engine stop and start ECU
|
1.
Upload the number of starter operations
2.
Reset air conditioning information
3.
Learning of air conditioning information
4.
Clear the zero point calibration data
5.
Perform zero point calibration of the deceleration sensor
6.
Check oil pump with motor assembly
|
Stop and start system
|
( )
|
| Update ECU security key
|
Vehicle control history (RoB) are stored
|
( )
|
| Power steering ECU assembly
|
Assist map writing
|
·
EPS warning light illuminates
|
( )
|
| Update ECU security key
|
Vehicle control history (RoB) are stored
|
( )
|
| Electric power steering column sub-assembly
|
Assist map writing
|
There is a difference in steering effort between turning left and right.
|
( )
|
with TAS Type:
Radio and Display Receiver Assembly
|
Register vehicle information
|
Network service
|
( )
|
| Telephone transceiver assembly
|
Register vehicle information
|
Emergency call service
|
( )
|
| Mobilephone battery
|
Reset mobilephone battery condition
|
Emergency call service
|
( )
|
| Central gateway ECU (network gateway ECU)
|
Update ECU security key
|
-
|
( )
|
w/o Parking Support Brake System:
Clearance warning ECU assembly
|
Bumper type registration
|
TOYOTA parking assist-sensor system (w/o Parking Support Brake System)
|
( )
|
| Update ECU security key
|
Vehicle control history (RoB) are stored
|
( )
|
w/o Parking Support Brake System:
|
Initialization of ultrasonic sensors
|
TOYOTA parking assist-sensor system (w/o Parking Support Brake System)
|
( )
|
w/ Parking Support Brake System:
Clearance warning ECU assembly
|
Update ECU security key
|
Vehicle control history (RoB) are stored
|
( )
|
·
Ultrasonic sensor detection angle
·
Steering angle neutral point
·
Registration of bumper type
·
Ultrasonic sensor detection angle registration
|
·
TOYOTA parking assist-sensor system (w/ Parking Support Brake System)
·
Parking support brake system
|
( )
|
w/ Parking Support Brake System:
Ultrasonic sensor (Including removal and installation)
|
·
Ultrasonic sensor detection angle
·
Ultrasonic sensor detection angle registration
|
w/ Parking Support Brake System:
Rear bumper assembly (Including removal and installation)
|
·
Ultrasonic sensor detection angle
·
Ultrasonic sensor detection angle registration
|
Parking support brake system
|
w/ Parking Support Brake System:
Front bumper assembly (Including removal and installation)
|
·
Ultrasonic sensor detection angle
·
Ultrasonic sensor detection angle registration
|
Parking support brake system
|
w/ Parking Support Brake System:
|
·
Ultrasonic sensor detection angle
·
Ultrasonic sensor detection angle registration
|
Parking support brake system
|
| Suspension, tires, etc.
|
Rear television camera assembly optical axis (Back camera position setting)
|
Parking assist monitor system
|
( )
|
| Steering sensor (Including removal and installation)
|
·
Steering angle neutral point
·
Adjust steering angle setting
|
Parking assist monitor system
|
( )
|
| Update ECU security key*2
|
Vehicle control history (RoB) are stored
|
( )
|
| Rear television camera assembly
|
Rear television camera assembly optical axis (Back camera position setting)
|
Parking assist monitor system
|
( )
|
| Blind spot monitor sensor
|
Blind spot monitor beam axis adjustment
|
Blind Spot Monitor System
|
( )
|
w/ Entry and Start System:
·
Certification ECU (smart key ECU assembly)
·
Steering lock ECU (steering lock actuator or upper bracket assembly)
·
Electrical key transmitter sub-assembly
·
ID code box (immobiliser code ECU)*4
·
Main body ECU (multiplex network body ECU)
|
Code registration
|
·
Wireless door lock control system (w/ Entry and Start System)
·
Entry and start system (for Entry function, Gasoline model)
·
Entry and start system (for Start function, Gasoline model)
|
See Service Bulletin for the registration method
|
for 3 Door:
Main body ECU (multiplex network body ECU)
|
ECU configuration
|
-
|
( )
|
w/o Entry and Start System:
·
Door control transmitter assembly
·
Transponder key ECU assembly
|
Code registration
|
Engine start function
|
See Service Bulletin for the registration method.
|
w/o Entry and Start System:
·
Door control transmitter module set sub-assembly
|
Register a new recognition code
|
Wireless door lock control system (w/o Entry and start system)
|
( )
|
·
No. 1 air conditioning radiator damper servo sub-assembly
·
No. 1 blower damper servo sub-assembly
|
Initialize servo motor (Air Conditioning System)
|
DTCs are stored
|
( )
|
| Air conditioning amplifier assembly
|
w/ Stop and Start System:
1.
Reset air conditioning information
2.
Learning of air conditioning information
|
Engine start function
|
( )
|
| Initialize servo motor (Air Conditioning System)
|
DTCs are stored
|
( )
|
·
Door window regulator sub-assembly
·
Power window regulator motor assembly
|
Initialize power window control system
|
·
Auto up and down function
·
Wireless transmitter-linked function
·
Key-off operation function
·
Catch protection function
·
Window open warning function
|
( )
|