2005-2008 Yaris · Service Manual ENGINE

P0016 Crankshaft Position - Camshaft Position Correlation (Bank 1 Sensor A)

Diagnostic trouble codes · Vehicles built from Nov 2005

DESCRIPTION

Refer to DTC P0335 (Click here) and DTC P0340 (Click here).
DTC No.
DTC Detection Conditions
Trouble Areas
P0016
Phase deviation in crankshaft and camshaft position sensor signals
(The MIL is illuminated and a DTC is immediately set when a malfunction is detected)
  1. Mechanical system malfunction (jumped teeth of timing chain, chain stretched)
  2. Camshaft timing gear
  3. Sensor plate (crankshaft timing gear)
  4. Timing chain
  5. Valve timing
  6. ECM

HINT:
  1. DTC P0016 is set when the engine is cranked 12 revolutions or more.
  2. This DTC shows that the camshaft is installed at an incorrect angle to the crankshaft (for example: due to a jumped tooth of the timing chain)


WIRING DIAGRAM

Refer to DTCs P0335 (Click here).

INSPECTION PROCEDURE

HINT:
Read freeze frame data using an intelligent tester. Freeze frame data record the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data, from the time the malfunction occurred.


1. CHECK VALVE TIMING (CHECK FOR LOOSE AND JUMPED TEETH ON TIMING CHAIN)

  1. G035846E01
    Remove the cylinder head cover (Click here).

  1. Turn the crankshaft pulley until the grooves of the crankshaft damper and oil pump are aligned.

  1. Check that the timing mark of the camshaft timing sprocket and the straight pin hole of the crankshaft timing sprocket are in the positions shown in the illustration.If not, turn the crankshaft 1 revolution (360°), then align the marks as above.

    OK:
    Timing marks on camshaft timing gears are aligned as shown in the illustration.

  1. Reinstall the cylinder head cover (Click here).



NG
Go to step 3
OK


2. REPLACE ECM


NEXT
Go to step 4
3. ADJUST VALVE TIMING

NEXT


4. CHECK WHETHER DTC OUTPUT RECURS (DTC P0016)

NOTICE:
After replacing the ECM or adjusting intake valve timing, confirm that the DTC output does not recur.

  1. Connect an intelligent tester to the DLC3.

  1. Turn the ignition switch on (IG) and turn the tester on.

  1. Clear DTCs (Click here).

  1. Switch the ECM from normal mode to check mode using the tester (Click here).

  1. Start the engine and warm it up.

  1. Allow the engine to idle for 1 minute or more, and then drive the vehicle for 1 minute or more.

  1. Confirm that no DTC is set, using the tester.

    OK:
    No DTC output


NEXT

END


← DIAGNOSTIC TROUBLE CODE CHART (from Nov 2005)P0045 Turbocharger / Supercharger Boost Control Solenoid Circuit / Open (from Nov 2005) →