Home › Power Source / Network ยท NETWORKING › CAN COMMUNICATION SYSTEM (for Separate Type Yaw Rate Sensor)

CAN COMMUNICATION SYSTEM (for Separate Type Yaw Rate Sensor) > PROBLEM SYMPTOMS TABLE

for Preparation Click here


HINT:
  1. Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
  2. Inspect the fuses and relays related to this system before inspecting the suspected areas below.
  3. Because the order of diagnosis is important to allow correct diagnosis, make sure to begin troubleshooting using How to Proceed with Troubleshooting when CAN communication system related DTCs are output (Click here).


Result of How to Proceed with Troubleshooting 
Symptom
Suspected Area
See page
Result of "How to proceed with Troubleshooting" is "Open in CAN Main Bus Line"
Open in CAN Main Bus Line
Click here
Result of "How to Proceed with Troubleshooting" is "Check CAN Bus Lines for Short Circuit"
Check CAN Bus Lines for Short Circuit
Click here
Result of "How to Proceed with Troubleshooting" is "Check CAN Bus Line for Short to +B"
Check CAN Bus Line for Short to +B
Click here
Result of "How to Proceed with Troubleshooting" is "Check CAN Bus Line for Short to GND"
Check CAN Bus Line for Short to GND
Click here
Result of "How to Proceed with Troubleshooting" is "Open in One Side of CAN Branch Line"
Open in One Side of CAN Branch Line
Click here

Communication Stop Mode Table 
Symptom
Suspected Area
See page
"Skid Control (ABS/VSC/TRAC)" is not displayed on intelligent tester
ABS and Traction Actuator (Skid Control ECU) Communication Stop Mode
Click here
"Air Conditioning Amplifier" is not displayed on intelligent tester
Air Conditioning Amplifier Communication Stop Mode
Click here
"Power Steering (EPS)" is not displayed on intelligent tester
Power Steering ECU Communication Stop Mode
Click here
"Spiral cable (Steering Angle Sensor)" is not displayed on intelligent tester
Steering Angle Sensor Communication Stop Mode
Click here
"Yaw Rate / Deceleration Sensor" is not displayed on intelligent tester
Yaw Rate Sensor Communication Stop Mode
Click here
"ECM (Engine)" is not displayed on intelligent tester
ECM Communication Stop Mode
Click here
"Main Body" is not displayed on intelligent tester
Main Body ECU Communication Stop Mode
Click here
"Combination Meter" is not displayed on intelligent tester
Combination Meter ECU Communication Stop Mode
Click here
"Airbag" is not displayed on intelligent tester
Center Airbag Sensor Communication Stop Mode
Click here