| Last Modified: 11-27-2007 | 1.6 A | |
| Service Category: Power Source/Network | Section: Battery/Charging | |
| Model Year: 2008 | Model: LX570 | Doc ID: RM000002BS200QX |
| Title: 3UR-FE BATTERY / CHARGING: GENERATOR: INSTALLATION (2008 LX570) | ||
INSTALLATION
1. INSTALL GENERATOR ASSEMBLY
|
(a) Install the generator with the 3 bolts and nut. Torque: 43 N·m (438 kgf·cm, 32 ft·lbf) |
|
(b) Connect the generator connector. |
(c) Connect the generator wire with the nut.
Torque: 12 N·m (122 kgf·cm, 9 ft·lbf)
(d) Install the terminal cap.
(e) Install the harness bracket to the generator with the bolt.
Torque: 31 N·m (316 kgf·cm, 23 ft·lbf)
2. CONNECT OIL COOLER PIPE ASSEMBLY
3. CONNECT VANE PUMP ASSEMBLY
4. INSTALL AIR CLEANER ASSEMBLY
5. INSTALL AIR CLEANER HOSE ASSEMBLY
6. INSTALL FRONT FENDER APRON SEAL FRONT RH
7. INSTALL FAN AND GENERATOR V BELT
8. INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY
9. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH
10. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH
11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected
.
12. INSTALL V-BANK COVER SUB-ASSEMBLY
13. INSTALL UPPER RADIATOR SUPPORT SEAL
14. INSTALL ENGINE ROOM SIDE COVER LH
15. INSTALL ENGINE ROOM SIDE COVER RH
|
|