| Last Modified: 11-27-2007 | 1.6 A | |
| Service Category: Engine/Hybrid System | Section: Engine Control | |
| Model Year: 2008 | Model: LX570 | Doc ID: RM000002H5900DX |
| Title: 3UR-FE ENGINE CONTROL: POWER STEERING OIL PRESSURE SWITCH: INSTALLATION (2008 LX570) | ||
INSTALLATION
1. INSTALL POWER STEERING OIL PRESSURE SWITCH
(a) Install a new O-ring to the oil pressure switch.
(b) Apply a light coat of engine oil to the O-ring of the oil pressure switch.
NOTICE:
- When reusing the oil pressure switch, inspect the O-ring.
- If the O-ring has scratches or cuts, replace the oil pressure switch.
|
(c) Using a 24 mm deep socket wrench, install the oil pressure switch. Torque: 21 N·m (214 kgf·cm, 15 ft·lbf) |
(d) Connect the oil pressure switch connector.
2. INSTALL FRONT HEIGHT CONTROL SENSOR SUB-ASSEMBLY RH
|
(a) Install the sensor with the bolt and nut. Torque: 13 N·m (127 kgf·cm, 9 ft·lbf) Torque: 5.6 N·m (57 kgf·cm, 50 in·lbf) |
(b) Connect the connector.
3. INSTALL FAN AND GENERATOR V BELT
4. INSTALL AIR CLEANER ASSEMBLY
5. INSTALL AIR CLEANER HOSE ASSEMBLY
6. ADD POWER STEERING FLUID
7. BLEED POWER STEERING FLUID
8. INSPECT FOR POWER STEERING FLUID LEAK
9. INSTALL FRONT FENDER APRON SEAL FRONT RH
10. INSTALL FRONT WHEEL
11. INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY
12. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH
13. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH
14. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected
.
15. PERFORM VEHICLE HEIGHT OFFSET CALIBRATION
16. ADJUST FRONT HEIGHT CONTROL SENSOR LINK SUB-ASSEMBLY
17. PERFORM ZERO POINT CALIBRATION OF G SENSOR
18. ADJUST HEADLIGHT ASSEMBLY
19. INSTALL V-BANK COVER SUB-ASSEMBLY
20. INSTALL UPPER RADIATOR SUPPORT SEAL
21. INSTALL ENGINE ROOM SIDE COVER RH
22. INSTALL ENGINE ROOM SIDE COVER LH
|
|