PROBLEM SYMPTOMS TABLE
Troubleshooting
- HINT:
- If there is no DTC output but the problem still occurs, check the circuits for each problem symptom in the order given in the table below and proceed to relevant troubleshooting page.
- Inspect the fuse before inspecting the circuits shown in the chart below.
- Inspect each malfunctioning circuit in numerical order for the corresponding symptoms.
- If there is no DTC output but the problem still occurs, check the circuits for each problem symptom in the order given in the table below and proceed to relevant troubleshooting page.
| Symptom |
Suspected area |
See page |
| "CHECK AWD SYSTEM" is displayed |
1. Check DTC again and make sure that the DTC is not output |
Click here
|
| 2. CAN communication system |
Click here
|
|
| 3. Multiplex communication system |
Click here
|
|
| 4. Hybrid control system |
Click here
|
|
| 5. Brake control system |
Click here
|
|
| 6. AWD warning circuit |
Click here
|
|
| 7. Skid control ECU |
Click here
|
|
| 8. HV control ECU |
Click here
|
- HINT:
- Use the table below to help find the cause of the problem. Check each part. If necessary, replace these parts.
| Symptom |
Suspected area |
See page |
| Wander |
1. Wheel alignment (Front) |
Click here
|
| 2. Wheel alignment (Rear) |
Click here
|
|
| 3. Steering linkage |
Click here
|
|
| 4. Hub bearing (Front) |
Click here
|
|
| 5. Hub bearing (Rear) |
Click here
|
|
| 6. Stabilizer bar (Front) |
Click here
|
|
| 7. Stabilizer bar (Rear) |
Click here
|
|
| Wheel shimmy |
1. Wheel balance |
Click here
|
| 2. Shock absorber (Front) |
Click here
|
|
| 3. Shock absorber (Rear) |
Click here
|
|
| 4. Hub bearing (Front) |
Click here
|
|
| 5. Hub bearing (Rear) |
Click here
|