53292A
1.REMOVE UPPER RADIATOR SUPPORT SEAL
53298
2.REMOVE COOL AIR INTAKE DUCT (for 4WD with TOYOTA Parking Assist-sensor System)
52129B
3.REMOVE FRONT BUMPER LOWER COVER (w/o TOYOTA Parking Assist-sensor System)
52129B
4.REMOVE FRONT BUMPER LOWER COVER (w/ TOYOTA Parking Assist-sensor System)
52822
5.REMOVE AIR INTAKE DUCT LH (w/ TOYOTA Parking Assist-sensor System)
52821
6.REMOVE AIR INTAKE DUCT RH (w/ TOYOTA Parking Assist-sensor System)
51405A
7.REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY
8.DRAIN ENGINE COOLANT
11259
9.REMOVE V-BANK COVER
16571
10.REMOVE NO. 1 RADIATOR HOSE
16572
11.REMOVE NO. 2 RADIATOR HOSE
16470
12.REMOVE RADIATOR RESERVOIR TANK
32907C
13.DISCONNECT OIL COOLER TUBE
16711
14.REMOVE FAN SHROUD
16323
15.REMOVE WATER INLET HOUSING
Disconnect the throttle body connector.
Slide 5 hose clamps and disconnect the 5 water by-pass hoses.
| *1 | No. 1 Water By-pass Hose |
| *2 | No. 2 Water By-pass Hose |
| *3 | No. 3 Water By-pass Hose |
| *4 | No. 4 Water By-pass Hose |
| *5 | No. 5 Water By-pass Hose |
| *6 | Oil Cooler Hose |
| *7 | No. 2 Oil Cooler Hose |
Slide the hose clamp and disconnect the oil cooler hose.
Slide the hose clamp and disconnect the No. 2 oil cooler hose.
Remove the 5 bolts and water inlet housing.
Remove the O-ring from the water outlet pipe.
Remove the gasket from the water pump assembly.
16604
16.REMOVE NO. 2 IDLER PULLEY SUB-ASSEMBLY
for Separate Type:
Remove the 2 bolts, 2 idler pulley cover plates, 2 No. 2 idler pulley sub-assemblies and 2 No. 2 idler pulley cover plates.
for Integrated Type:
Remove the 2 bolts and 2 No. 2 idler pulley sub-assemblies.
44310
17.DISCONNECT VANE PUMP ASSEMBLY
Disconnect the 2 connectors.
Detach the 2 wire harness clamps.
Remove the 2 bolts and disconnect the vane pump assembly.
27020
18.REMOVE GENERATOR ASSEMBLY
88320
19.REMOVE COOLER COMPRESSOR ASSEMBLY
16620
20.REMOVE V-RIBBED BELT TENSIONER ASSEMBLY
16100
21.REMOVE WATER PUMP ASSEMBLY
Remove the 17 bolts, water pump assembly and gasket.