Home › Engine / Hybrid System › FA20 INTAKE / EXHAUST › INTAKE MANIFOLD › from 2016.06
RM2090E _51 Engine / Hybrid System _060669 FA20 INTAKE / EXHAUST _0297515 INTAKE MANIFOLD A

FA20 INTAKE / EXHAUST  INTAKE MANIFOLD  INSTALLATION  


PROCEDURE

Hide 17111 1.INSTALL INTAKE MANIFOLD

a.

Install the 2 new gaskets to the intake manifold.


b.

Install the intake manifold with the 6 bolts.

Torque:
25 N*m (255 kgf*cm, 18 ft.*lbf)


c.

Engage the 2 clamps and 4 connectors, and connect the wire harness.


d.

Connect the fuel pump connector.


e.

Engage the clamp and connect the engine wire harness.


f.

Engage the 3 clamps and connect the wire harness. (for LHD)


g.

Engage the 5 clamps and connect the battery cable. (for RHD)


h.

Connect the purge valve connector.


i.

Connect the manifold absolute pressure sensor connector.


Hide 12261 2.CONNECT VENTILATION HOSE

a.

Connect the ventilation hose.


Hide 3.INSTALL COMPRESSOR WITH MAGNETIC CLUTCH (for Aluminum Intake Manifold)

Hide 16361A 4.INSTALL FAN AND GENERATOR V BELT (for Aluminum Intake Manifold)

Hide 44771 5.CONNECT VACUUM TUBE CONNECTOR HOSE (for Manual Transmission)

Hide 12601B 6.INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY (for Resin Intake Manifold)

a.

Engage the 3 claws and install the No. 1 engine cover sub-assembly.


Hide 23807 7.CONNECT FUEL DELIVERY PIPE SUB-ASSEMBLY

a.

Connect the No. 2 fuel vapor feed hose.


b.

Install the bolt and connect the fuel delivery pipe sub-assembly.

Torque:
6.4 N*m (65 kgf*cm, 57 in.*lbf)


Hide 22030 13.CONNECT THROTTLE WITH MOTOR BODY ASSEMBLY

a.

Install a new gasket to the intake manifold.


b.

Install the throttle with motor body assembly to intake manifold with the 4 bolts.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


Hide 14.INSTALL AIR CLEANER CAP WITH AIR CLEANER HOSE

Hide 15.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Hide 16.INSPECT FUEL PUMP OPERATION AND INSPECT FOR FUEL LEAK

Hide 22030 17.INSPECT THROTTLE WITH MOTOR BODY ASSEMBLY