The skid control ECU (brake actuator assembly) is connected to the combination meter assembly via CAN communication.
Pressing the VSC OFF switch turns off TRC, and pressing and holding this switch turns off TRC and VSC. If TRC is turned off, the TRC OFF indicator light will come on.
When replacing the skid control ECU (brake actuator assembly), perform VSC sensor neutral memorization.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>CALIBRATION
Check if a CAN communication system DTC is output.
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>DIAGNOSIS SYSTEM
| Result | Proceed to |
|---|---|
| DTC is not output. | A |
| DTC is output. | B |
A
B
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
Check if the skid control ECU (brake actuator assembly) connector is securely connected.
The connector is securely connected.
OK
NG
Check the battery voltage.
11 to 14 V
OK
NG
w/ 150 A Generator
w/ 130 A Generator
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Select the Data List using the GTS.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| TRC(TRAC)/VSC Off Mode | TRC/VSC OFF mode / Normal, TRC(TRAC) OFF or VSC OFF | Normal: Normal mode
TRC(TRAC) OFF: TRC OFF mode VSC OFF: VSC OFF mode |
- |
Using the GTS, check that the switch condition displayed on the GTS changes according to VSC OFF switch operation.
The GTS display changes according to VSC OFF switch operation.
OK
NG
Perform an Active Test of the combination meter assembly (meter CPU) using the GTS.
Click hereVehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>DATA LIST / ACTIVE TEST
Check the combination meter assembly.
The TRC OFF indicator light turns on or off in accordance with the Active Test operation.
If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step before replacing parts.
OK
NG
Remove the VSC OFF switch.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VSC OFF SWITCH>REMOVAL
Inspect the VSC OFF switch.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VSC OFF SWITCH>INSPECTION
OK
NG
Disconnect the skid control ECU (brake actuator assembly) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A5-12 (CSW1) - D35-5 | Always | Below 1 Ω |
| A5-12 (CSW1) - Body ground | Always | 10 kΩ or higher |
| D35-8 - Body ground | Always | Below 1 Ω |
If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step before replacing parts.
OK
NG