Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM › from 2016.06
RM2090E _54 Brake _060684 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0297617 VEHICLE STABILITY CONTROL SYSTEM T

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM  PROBLEM SYMPTOMS TABLE  


If there are no DTCs output and the problem still occurs, check the suspected areas for each problem symptom in the order given in the following table and proceed to the relevant troubleshooting page.

NOTICE:

When replacing the brake actuator assembly, sensors, etc., turn the ignition switch off.


HINT:
·

Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.

·

Inspect the fuses and relays related to this system before inspecting the suspected areas below.



Vehicle Stability Control System
Symptom Suspected Area See page
ABS, BA and/or EBD does not operate. Check for DTCs again and make sure that DTCs are not output. (Click here)
Power source circuit (Click here)
Front speed sensor circuit (Click here)
Rear speed sensor circuit (Click here)
Check the brake actuator assembly using the GTS. (Check brake actuator assembly operation using the Active Test function.) If abnormal, check the hydraulic circuit for leaks. (Click here)
If the symptoms still occur even after the above suspected areas have been inspected and proved to be normal, replace the brake actuator assembly. (Click here)
ABS, BA and/or EBD does not operate efficiently. Check for DTCs again and make sure that DTCs are not output. (Click here)
Front speed sensor circuit (Click here)
Rear speed sensor circuit (Click here)
Stop light switch circuit (Click here)
Check the brake actuator assembly using the GTS. (Check brake actuator assembly operation using the Active Test function.) If abnormal, check the hydraulic circuit for leaks. (Click here)
If the symptoms still occur even after the above suspected areas have been inspected and proved to be normal, replace the brake actuator assembly. (Click here)
ABS sensor DTC check cannot be done. Check for DTCs again and make sure that DTCs are not output. (Click here)
Check CAN communication system. (Click here)
If the symptoms still occur even after the above suspected areas has been inspected and proved to be normal, replace the skid control ECU. (Click here)
ABS warning light abnormal (Remains on). Adjust the stop light switch assembly. (Click here)
ABS warning light circuit (Click here)
Skid control ECU (Click here)
ABS warning light abnormal (Does not come on). ABS warning light circuit (Click here)
Skid control ECU (Click here)
Brake warning light abnormal (Remains on). Brake warning light circuit (Click here)
Skid control ECU (Click here)
Brake warning light abnormal (Does not come on). Brake warning light circuit (Click here)
Skid control ECU (Click here)
VSC and/or TRC does not operate. Check for DTCs again and make sure that DTCs are not output. (Click here)
Check the engine control system. (Click here)
Check the automatic transmission control system. (Click here)
Power source circuit (Click here)
Check the hydraulic circuit for leaks. -
Front speed sensor circuit (Click here)
Rear speed sensor circuit (Click here)
Steering sensor circuit (Click here)
Replace the ECM. (Click here)
If the symptoms still occur even after the above suspected areas have been inspected and proved to be normal, replace the brake actuator assembly. (Click here)
VSC sensor DTC check cannot be done. Check for DTCs again and make sure that DTCs are not output. (Click here)
Check CAN communication system. (Click here)
If the symptoms still occur even after the above suspected areas has been inspected and proved to be normal, replace the skid control ECU. (Click here)
TRC OFF indicator light abnormal (Remains on). TRC OFF indicator light circuit (Click here)
Skid control ECU (Click here)
TRC OFF indicator light abnormal (Does not come on). TRC OFF indicator light circuit (Click here)
Skid control ECU (Click here)
VSC OFF indicator light abnormal (Remains on). VSC OFF indicator light circuit (Click here)
Skid control ECU (Click here)
VSC OFF indicator light abnormal (Does not come on). VSC OFF indicator light circuit (Click here)
Skid control ECU (Click here)
TRACK indicator light abnormal (Remains on). TRACK indicator light circuit (Click here)
Skid control ECU (Click here)
TRACK indicator light abnormal (Does not come on). TRACK indicator light circuit (Click here)
Skid control ECU (Click here)
Slip indicator light abnormal (Remains on). Adjust the stop light switch assembly. (Click here)
Slip indicator light circuit (Click here)
Skid control ECU (Click here)
Slip indicator light abnormal (Does not come on). Slip indicator light circuit (Click here)
Skid control ECU (Click here)
Sensor check cannot be done. Check CAN communication system. (Click here)
Skid control ECU (Click here)
Hill-start assist does not operate. Check CAN communication system. (Click here)
Hill start assist indicator circuit (Click here)