The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the transmission control cable assembly removal/installation are shown below.
*1: When performing learning using the GTS.
When the engine is hot, do not touch high-temperature areas such as the engine or exhaust pipe.
Touching high-temperature areas such as the engine and exhaust pipe could result in burns.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.SECURE VEHICLE
Fully apply the parking brake and chock a wheel.
Make sure to apply the parking brake and chock a wheel before performing this procedure.
If the vehicle is not secure and the shift lever is moved to N, the vehicle may suddenly move, possibly resulting in an accident or serious injury.
3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Click hereGeneral>MAINTENANCE>3ZR-FAE BATTERY>REMOVAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
28800
4.REMOVE BATTERY
33504F
5.REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY
6.REMOVE REAR CONSOLE BOX ASSEMBLY
51410
7.REMOVE NO. 1 ENGINE UNDER COVER
51444A
8.REMOVE REAR ENGINE UNDER COVER LH
11212
9.REMOVE NO. 2 CYLINDER HEAD COVER
53141F
10.REMOVE RADIATOR COVER
17751
11.REMOVE NO. 1 AIR CLEANER INLET
17705
12.REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE
17701
13.REMOVE AIR CLEANER CASE SUB-ASSEMBLY
89661
14.REMOVE ECM
74404A
15.REMOVE BATTERY CLAMP SUB-ASSEMBLY
57533B
16.REMOVE FRONT FLOOR CENTER BRACE
17410
17.REMOVE FRONT EXHAUST PIPE ASSEMBLY (TWC: Front and Rear Catalyst)
58151
18.REMOVE FRONT NO. 1 FLOOR HEAT INSULATOR
Remove 3 nuts and front No. 1 floor heat insulator from the vehicle body.
33820B
19.REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY
Move the shift lever to N.
|
Remove in this Direction |
Disconnect the end of the transmission control cable assembly from the floor shift shift lever assembly.
| *1 | Slider |
|
Push |
|
Remove in this Direction |
Push in the slider and remove the transmission control cable from the floor shift shift lever assembly as shown in the illustration.
Remove the nut to disconnect the transmission control cable assembly from the control shaft lever.
Remove the clip to disconnect the transmission control cable assembly from the No. 1 transmission control cable bracket.
Remove the nut to disconnect the transmission control cable assembly from the transmission control cable support.
Remove the nut.
Disengage the guide to disconnect the transmission control cable assembly from the vehicle body.
Remove the 2 nuts and transmission control cable assembly from the vehicle body.