Before replacing the main body ECU (multiplex network body ECU), refer to Service Bulletin.*1
*1: w/ Entry and Start System
When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
Inspect the fuses for circuits related to this system before performing the followingprocedure.
*1: for LED Type
*2: for Bulb Type
| Symptom | Suspected Area | Link |
|---|---|---|
| Left or right license plate light does not illuminate | License plate light assembly |
|
| Harness or connector | - |
*1: for LED Type
*2: for Bulb Type
*1: for LED Type
*2: for Bulb Type
*1: for Driver Door-linked Auto Light Turn-off System