| U0104
|
Lost Communication with Driving Support ECU
|
No communication from the driving support ECU assembly continues.
|
·
Driving support ECU assembly branch line or connector
·
Power source circuit of driving support ECU assembly
·
Driving support ECU assembly ground circuit
·
Driving support ECU assembly
|
The network gateway ECU stores DTCs when it detects a communication stop or network communication error for ECUs connected to sub bus 2.
|
|
| U0199
|
Lost Communication with "Door Control Module A"
|
No communication from the outer mirror control ECU assembly continues.
|
·
Outer mirror control ECU assembly (for driver side) branch line or connector
·
Power source circuit of outer mirror control ECU assembly (for driver side)
·
Outer mirror control ECU assembly (for driver side) ground circuit
·
Outer mirror control ECU assembly (for driver side)
|
The main body ECU (multiplex network body ECU) stores DTCs when it detects a communication stop or network communication error for ECUs connected to sub bus 1.
|
|
| U0200
|
Lost Communication with "Door Control Module B"
|
No communication from the outer mirror control ECU assembly continues.
|
·
Outer mirror control ECU assembly (for front passenger side) branch line or connector
·
Power source circuit of outer mirror control ECU assembly (for front passenger side)
·
Outer mirror control ECU assembly (for front passenger side) ground circuit
·
Outer mirror control ECU assembly (for front passenger side)
|
The main body ECU (multiplex network body ECU) stores DTCs when it detects a communication stop or network communication error for ECUs connected to sub bus 1.
|
|
| U0208
|
Lost Communication with "Seat Control Module A"
|
No communication from the position control ECU and switch assembly continues.
|
·
Position control ECU and switch assembly (for driver side) branch line or connector
·
Power source circuit of position control ECU and switch assembly (for driver side)
·
Position control ECU and switch assembly (for driver side) ground circuit
·
Position control ECU and switch assembly (for driver side)
|
The main body ECU (multiplex network body ECU) stores DTCs when it detects a communication stop or network communication error for ECUs connected to sub bus 1.
|
|
| U0233
|
Lost Communication with Blind Spot Monitor Master Module
|
No communication from the blind spot monitor sensor RH continues.
|
·
Blind spot monitor sensor RH branch line or connector
·
Power source circuit of blind spot monitor sensor RH
·
Blind spot monitor sensor RH ground circuit
·
Blind spot monitor sensor RH
|
The network gateway ECU stores DTCs when it detects a communication stop or network communication error for ECUs connected to sub bus 2.
|
|
| U0235
|
Lost Communication with Cruise Control Front Distance Range Sensor
|
No communication from the millimeter wave radar sensor assembly continues.
|
·
Open or short in sub bus 13 main line or connector
·
Millimeter wave radar sensor assembly
·
Power source circuit of millimeter wave radar sensor assembly
·
Millimeter wave radar sensor assembly ground circuit
|
The driving support ECU assembly stores DTCs when it detects a communication stop or network communication error for ECUs connected to sub bus 13.
|
|
| U023A
|
Lost Communication with Front Camera Module
|
No communication from the lane departure warning camera continues.
|
·
Lane departure warning camera branch line or connector
·
Power source circuit of lane departure warning camera
·
Lane departure warning camera ground circuit
·
Lane departure warning camera
|
The network gateway ECU stores DTCs when it detects a communication stop or network communication error for ECUs connected to sub bus 2.
|
|
| U0265
|
Lost Communication with Parking Assist Monitor Module
|
No communication from the rear television camera assembly continues.
|
·
Rear television camera assembly branch line or connector
·
Power source circuit of rear television camera assembly
·
Rear television camera assembly ground circuit
·
Rear television camera assembly
|
Network gateway ECU stores DTCs when it detects a communication stop or network communication error for ECUs connected to sub bus 2.
|
|
| U1002
|
Lost Communication with Gateway Module (Main Body ECU)
|
Main body ECU cannot receive signals from all ECUs that have been memorized as those connected to sub bus 1.
|
·
Open or short in Sub bus 1 main line or connector
·
Open or short in Sub bus 1 branch line or connector
·
Main body ECU (Multiplex network body ECU)
·
Outer mirror control ECU assembly (for Driver side)
·
Outer mirror control ECU assembly (for Front passenger side)
·
Position control ECU and switch assembly (for Driver side)
·
Open or short in CAN No. 3 junction connector
·
Open or short in CAN No. 4 junction connector
|
The main body ECU (multiplex network body ECU) stores DTCs when it detects a communication stop or network communication error for ECUs connected to sub bus 1.
|
|
| U1002
|
Lost Communication with Gateway Module (Sensor Bus)
|
The driving support ECU assembly does not receive signals from all ECUs that have been memorized as those connected to sub bus 13.
|
·
Open or short in sub bus 13 main line or connector
·
Driving support ECU assembly
·
Power source circuit of driving support ECU assembly
·
Driving support ECU assembly ground circuit
·
Millimeter wave radar sensor assembly
·
Power source circuit of millimeter wave radar sensor assembly
·
Millimeter wave radar sensor assembly ground circuit
|
The driving support ECU assembly stores DTCs when it detects a communication stop or network communication error for ECUs connected to sub bus 13.
|
|
| U1002
|
Lost Communication with Gateway Module (Network Gateway ECU)
|
The network gateway ECU does not receive signals from all ECUs that have been memorized as those connected to sub bus 2.
|
·
Open or short in sub bus 2 main lines or connector
·
Short in sub bus 2 branch lines or connector
·
Network gateway ECU
(w/ Parking Assist Monitor System)
·
Blind spot monitor sensor RH
(w/ Blind Spot Monitor System)
·
Rear television camera assembly
(w/ Parking Assist Monitor System)
·
Driving support ECU assembly
(w/ Pre-crash Safety System)
·
Lane departure warning camera
(w/ Lane Departure Alert System)
·
Open or short in CAN No. 5 junction connector
(w/ Parking Assist Monitor System)
·
Open or short in CAN No. 6 junction connector
(w/ Parking Assist Monitor System)
·
Open or short in CAN No. 7 junction connector
(w/ Parking Assist Monitor System)
·
Open or short in CAN No. 8 junction connector
(w/ Lane Departure Alert System)
·
Open or short in CAN No. 9 junction connector
(w/ Parking Assist Monitor System)
|
The network gateway ECU stores DTCs when it detects a communication stop or network communication error for ECUs connected to sub bus 2.
|
|