Home › Engine / Hybrid System › 2AR-FXE INTAKE / EXHAUST › INTAKE MANIFOLD
RM2040EQ _51 Engine / Hybrid System _014696 2AR-FXE INTAKE / EXHAUST _0074923 INTAKE MANIFOLD A

2AR-FXE INTAKE / EXHAUST  INTAKE MANIFOLD  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2. DISCHARGE FUEL SYSTEM PRESSURE

Hide 64718C 3.REMOVE LUGGAGE TRIM SERVICE HOLE COVER

Hide 4.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 22030 5.REMOVE THROTTLE WITH MOTOR BODY ASSEMBLY

Hide 6.REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY

Hide 55702A 7.REMOVE FRONT OUTER COWL TOP PANEL SUB-ASSEMBLY

Hide 25620 8.REMOVE EGR VALVE ASSEMBLY

Hide 89421 9.REMOVE MANIFOLD ABSOLUTE PRESSURE SENSOR

Hide 17111 10.SEPARATE INTAKE MANIFOLD

a.
A257341

Disconnect the No. 2 ventilation hose.


b.
A259044

Disconnect the heated oxygen sensor connector.


c.
A257342

Disconnect the 6 wire harness clamps.


d.
A257344

Remove the 6 bolts to separate the intake manifold from the engine assembly.


Hide 23901 11.DISCONNECT FUEL TUBE SUB-ASSEMBLY

Hide 23814B 12.REMOVE FUEL DELIVERY PIPE

Hide 17111 13.REMOVE INTAKE MANIFOLD

a.

Remove the intake manifold from the vehicle.


b.
A257345

Remove the gasket from the intake manifold.


c.
A257346

Remove the bolt and wire harness clamp bracket.


d.
A257347

Remove the vacuum hose from the intake manifold.


e.
A258678

Remove the fuel vapor feed hose from the intake manifold.