Use the same procedure for the LH side and RH side.
The following procedure is for the LH side.
If the sensor rotor needs to be replaced, replace the rear axle hub and bearing assembly.
The rear speed sensor is a component of the rear axle hub and bearing assembly. If the rear speed sensor malfunctions, replace the rear axle hub and bearing assembly.
42450B
1.INSTALL REAR AXLE HUB AND BEARING ASSEMBLY
Install the rear axle hub and bearing assembly.
Click hereDrivetrain>AXLE AND DIFFERENTIAL>REAR AXLE HUB>INSTALLATION
The rear speed sensor is a component of the rear axle hub and bearing assembly. If the sensor malfunctions, replace the rear axle hub and bearing assembly.
If the sensor rotor needs to be replaced, replace the rear axle hub and bearing assembly.
2.INSPECT REAR AXLE HUB BEARING LOOSENESS
3.INSPECT REAR AXLE HUB RUNOUT
89516D
4.CONNECT SKID CONTROL SENSOR WIRE
Connect the connector to the rear speed sensor.
42431
5.INSTALL REAR DISC
42491
6.INSTALL PARKING BRAKE SHOE ADJUSTING HOLE PLUG
7.INSTALL REAR DISC BRAKE CALIPER ASSEMBLY
8.CONNECT CABLE TO AUXILIARY BATTERY NEGATIVE TERMINAL
Connect the cable to the negative (-) auxiliary battery terminal.
Click herePower Source / Network>2AR-FXE BATTERY / CHARGING>AUXILIARY BATTERY>INSTALLATION
Connect the reservoir level switch connector.
Clear the DTCs.
55702A
9.INSTALL FRONT OUTER COWL TOP PANEL SUB-ASSEMBLY
10.INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY
11.ADJUST PARKING BRAKE
12.INSTALL REAR WHEEL
13.CHECK FOR SPEED SENSOR SIGNAL